Your cart is empty.
Your cart is empty.Product Description
16" Slim Push Pull 12V Electric Radiator Cooling Fan
Blade Size: 16 Inch，
Blade Type: Curved
Motor Size: 120 Watts，
CFM Rating: 1000 CFM
RPM Rating: 2000±10% RPM
10 Blades，12 Volts
6.6 AMP DRAW
Material: Plastic Shroud/Steel Motor
Professional Installation is Highly Recommended
Thermostat Kit:
Adjustable fan thermostat with complete installation wiring kit. Measures liquid or contact temperature and turns on electric fan. Flexible temperature turn dial control range of 32-250'F (0-120'C). Thermostat can be wired to turn fan on or off when set temperature is hit. Turn-off temperature is always 15 degrees less than turn-on. Thermostat dial has both Celsius and Fahrenheit temperature markings. Probe can be pushed into radiator, condenser, oil cooler fins or inlet tube. Capillary thermostat tube wire is 30 inches in length.
4 X nylon mounting rod, 8 X foam pad, 4 X spring, 4 X fixed buckle.
Accessories complete, please rest assured to use
Turn Dial w/ Temp Markers
Thermostat dial has both Celsius and Fahrenheit temperature markings.
1X Mounting Bracket
Accessories complete, please rest assured to use
Red copper wire
High quality red copper wire, good conductivity, stable transmission
Terminal & Heat shrink tube
Accessories complete, please rest assured to use
Screws
Mounting Screws
Nato
Reviewed in the United States on September 6, 2024
La calidad y lo ligero
Todd Ramsey
Reviewed in the United States on September 13, 2024
A new engine was installed, they left out parts, so no air flow on the condenser coils at idle.. with this fan mounted to the coils, ice cold AC all the time. Now high and low pressure readings have stabilized.
Z
Reviewed in the United States on August 30, 2024
Works good
neal deitz
Reviewed in the United States on June 26, 2024
Used it as a fan in my golf cart and works like a champ! Little loud obviously, but down here in Texas we take that over the heat!! Price was perfect as well
Gena stafford
Reviewed in the United States on June 23, 2024
Arrived with non working thermostat, and the "directions" were obviously referencing some other thermostat. It would work as a heater thermostat, that turns off when the set temperature is reached. The pin that is supposed to turn ON when the set temp is reached DID NOT work. I took it apart, identified the appropriate set of contacts, and saw they were indeed closing, but not allowing electricity to flow through them. I inserted the tip of a knife in between the contacts and kind of scraped and it immediately started working. There was either a coating, or, more likely, they put some kind of "electrical grease" on the contacts. I have had BAD luck with that stuff SCREWING up a connection in the past. Anyway, if your thermostat does work, or you get it working, you are going to want to feed power into it via the "C" (common) terminal, then use the terminal next to that, I believe it is labeled "2" to supply the relay switch terminal, in order for this to working as a cooling fan. If for some reason you want the fan to shut OFF when the sensor gets hot, then feed power in at C, out at 1.
Antonio Lauro
Reviewed in the United States on May 15, 2024
We have ordered two units and both bad thermostat. The cool side works but the heat side does not. Now we most likely have to buy a new one again
Grumblebear
Reviewed in the United States on February 2, 2024
I really like this fan. I believe it is the most powerful 12 volt fan I’ve ever seen. The mounting system leaves a bit to be desired but it is functional.
Michael Thiry
Reviewed in the United States on December 4, 2024
Thermostat that came with the fan does not work. Also about half the required hardware was missing. Please send a functional thermostat.
Recommended Products
$54.99
$ 25 .99 $25.99