Your cart is empty.
Your cart is empty. Specifications:
Rated voltage: 300V
Rated current: 25A
Pin and cage: Brass
Terminal pitch: 5mm
PCB Material: FR4
Input Cable Specification: 26-14 AWG / 0.5mm²~2.5mm²
Output Cable Specification: 26-14 AWG / 0.5mm²~2.5mm²
Contact resistance: 20 mΩ
Rail Width: C45(35mm)
Size: 42mm x 48.6mm x 46.48mm / 1.65" x 1.91" x 1.83"(L x W x H)
Package inlcuded:
1x 2 in 6 Out DIN Rail and Panel Mounting Power Distribution Module
Koritonics
Reviewed in the United States on June 20, 2024
Terminal block is easy to use and pretty well built. I was able to connect wires to it real easy and use the screws to tighten down pretty easily without stripping the screw head out. So the screws are also not super cheap made
turtlex0x
Reviewed in the United States on September 28, 2023
very nice 2x8 fits well on the DIN rail. easy to use. Thanks
Firebyphoenix112
Reviewed in the United States on September 15, 2022
Feels like good material but moves around on the rail too much. Doesn't hold very tight.
Katharos
Reviewed in the United States on August 14, 2022
This is actually 1in 4 out, there’s no isolation between both positive input and the same for the Negative input.It says 2in 4 out I guess the countPositive and negative as one and two but it makes no sense either way.If you do buy this keep in mind you can only connect one feed to the input +/-.
Ashley P
Reviewed in the United States on November 19, 2022
Works great, I just wish it was a little tighter on the rail - you can easily slide it around. - in fact, even the weight of a wire can move it.
Eduardo Corea Blandon
Reviewed in the United States on April 30, 2021
Excelente
Recommended Products
