Your cart is empty.
Your cart is empty.Fitment : Fits Most of 1995-UP Harley Sportster Models(Nightsters, Irons, 48,72) Made from Cold Rolled Steel,This Gas Tank Lift Risers Kit can provide Better Air-Flow - engine runs cooler All Stainless Steel Hardware,Durable Black Powder Coat Finish Top of the line tank lift kit which can lift your tank 2 inches higher. Easy to install,Item is a direct bolt on, no need to remove your tank! Simply unbolt, lift up and install new hardware. Package Include: 1 set of Tank Lift Kit
Chodes Mcgee
Reviewed in the United States on March 20, 2025
Easy to install. Defiantly improved the look of my bike
Greg
Reviewed in Canada on March 15, 2025
Not the best
Phillip C
Reviewed in the United States on February 15, 2025
Install is a little awkward. The bolts for the tank sit right on the frame, so you have to tighten them before you can run the long threaded bolt that runs through the frame cause you can’t fit a wrench to tighten them after. Also, no instructions of any kind. The parts aren’t marked, it took trial and error to figure out what went where, when, and how. My biggest gripe was quality, I had to retread one of the bolts because the threading was full of spurs. Hard to recommend.
Rich
Reviewed in the United States on August 27, 2024
Does not lift the tank like it should
Customer
Reviewed in the United States on September 26, 2023
Very easy to install fit perfect. Tank lift made the bike look cool and gave me extra room to hide wires definitely recommend. Good solid lift bar order with confidence
Joshua M. Walls
Reviewed in the United States on September 14, 2023
They definitely raised the tank. However they are Flexing and I don’t think I’d trust them on the bike
Vincent O
Reviewed in the United States on March 22, 2023
Item works as it should and looks nice.
Lee
Reviewed in the United States on October 28, 2022
Arrived with no way to hold it on to the tank. One long bolt with some washers, but no nuts to put on the end of the part that attaches to the tank. Had to run to the hardware store to figure out size and thread pitch etc so I could get the two nuts needed to get this installed.
Recommended Products
