Shopping Cart

Your cart is empty.

Your cart is empty.

20 Pcs Dual High-Power MOS FET Trigger Switch Drive Module PWM Regulator Adjustment Electronic Switch Control Board DC 5V-36V 400W

Free shipping on orders over $29.99

$16.99

$ 7 .99 $7.99

In Stock

About this item

  • Total 20pcs with professional design. The output can control high-power equipment, motor, bulb, LED strip, DC motor, micro pump, solenoid valve, etc. It can input PWM, control motor speed, lamp brightness, etc
  • We can use dual MOS parallel active output, lower internal resistance, larger current and strong power.
  • Operating Voltage: DC DC 5V--36V; continuous current 15A at normal temperature; power: 400W; The maximum current can reach 30A under auxiliary cooling conditions.
  • Supports the PWM signal, the signal frequency is 0--20KHZ, which can control motor speed, lamp brightness and so on.
  • Wide voltage, support PWM;Easily control high-power devices;Service life: unlimited switch; working temperature: -40-85 ¡ã C; size: 1.34x0.7x0.5 inch/3.4 x 1.7 x1.2cm(L*W*H)


Description:
1. Total 20pcs with professional design. The output can control high-power equipment, motor, bulb, LED strip, DC motor, micro pump, solenoid valve, etc. It can input PWM, control motor speed, lamp brightness, etc.
2. We can use dual MOS parallel active output, lower internal resistance, larger current and strong power.
3. Operating Voltage: DC DC 5V--36V; continuous current 15A at normal temperature; power: 400W; The maximum current can reach 30A under auxiliary cooling conditions.
4. Supports the PWM signal, the signal frequency is 0--20KHZ, which can control motor speed, lamp brightness and so on.
5. Wide voltage, support PWM;Easily control high-power devices;Service life: unlimited switch; working temperature: -40-85 ¡ã C; size: 1.34x0.7x0.5 inch/3.4 x 1.7 x1.2cm(L*W*H)
Package:
20x MOS FET Trigger Switch


AJ
Reviewed in the United States on December 9, 2024
At less than $1 per piece, these mofset switches are better than expected. Only 1 in the batch of 20 did not function upon arrival.They’re simple switches which use PWM to regulate output amperage with constant voltage.I just wish that the terminal blocks were all mounted on the same side so I could more easily run many of these units in parallel. They’re ok for my application which calls for 16 units, but wiring is a bit of a mess. They’d be perfect for an application requiring only a handful of units.