Shopping Cart

Your cart is empty.

Your cart is empty.

2PCS Flush Mounting Fishing Rod Holders with Rubber Cap, Liner and Gasket (Screws Included)

Free shipping on orders over $29.99

$24.99

$ 10 .99 $10.99

In Stock

About this item

  • Spec: L= 9" (229mm), Flange Angle = 90 Degrees, PVC Liner
  • Material: Quality Stamped 304 Grade Stainless Steel
  • Finish: Flange Face and Flange Edge Polished
  • UV PCV Liner with Cap, Rubber Gasket included
  • Requires a 2" installation hole and three #12 screws (Included)



Charles Levy
Reviewed in the United States on March 24, 2025
Very nice quality for the cost..Highly recommend.
SaltyDog
Reviewed in the United States on March 24, 2025
Nice stainless steel rod holders. Vertical holding is just what I wanted. I mounted these to my floating dock to double as catfishing rod holders and to hold patio umbrellas in the summer for shade. I docked one star because they did not come with the screws, as was advertised.
Jose Torres
Reviewed in the United States on July 27, 2024
Recomendado
tony malshuk
Reviewed in the United States on May 6, 2024
Installed on my boat and works great.I love the way they mount flat on my boat .
Billy Ray
Reviewed in the United States on May 29, 2024
It holds rods good
Stevec
Reviewed in the United States on April 20, 2024
Getting boat ready for fishing this summer replace rod holder that were look worn outThese were easy to install looks great on the boat
BENNY NASH
Reviewed in the United States on October 3, 2023
Bought these to used as a handle support for entering and leaving the boat. I do not fish so no rods on my boat. Make sure to measure where you want to mouth them. they are heavy metal with a rubber gasket. there is no metal mounting plate for under the mounting point. I still plan to mount them but may have to put them in the area on the gunnel within the step area. They have a rubber cover to close it against the water when not being used. Well worth the money.
SwampDawg
Reviewed in the United States on June 8, 2019
They r made of stainless and pretty stout I put them on my boat for my bent butt tuna pole as I have a bad back and have to leave it in the hole I hook a monster grouper and almost got him to the boat, when he dove to the bottom I have 100lbs brad and the drag fully set there was no stopping him and he bent one or them and about pulled the screws out but it hung in there other then that, there better then I expected, I will order them again, I will recommend them to people