Shopping Cart

Your cart is empty.

Your cart is empty.

2PCS TCS34725 RGB Color Sensor Module with IR Filter and White LED I2C Interface

4.7 (1) Write Review
Free shipping on orders over $29.99

$7.99

$ 3 .99 $3.99

In Stock

About this item

  • The TCS34725 device provides a digital return of red, green, blue (RGB), and clear light sensing values. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately.
  • Advantage: Data Rates up to 400 kbit/s; Strong point: Input Voltage Levels Compatible with VDD or 1.8 V Bus.
  • Low Power: 2.5-uA Sleep State; Feature: I2C Fast Mode Compatible Interface.
  • Characteristic: Programmable Upper and Lower Thresholds with Persistence Filter.
  • Applications: It is used for RGB LED Backlight Control, Light Color Temperature Measurement, Ambient Light Sensing for Display, Backlight Control, Fluid and Gas Analysis, Product Color Verification and Sorting.


TCS-34725 TCS34725 RGB Color Light Sensor Colour Recognition Module

Specification:

- Working Voltage: 3.3 or 5V

- Detection distance: 3-10mm

- Interface: IIC interface and 2.54 pitch

- Red, Green, Blue (RGB), and White Light Sensing with IR Blocking Filter

- Programmable Analog Gain and Integration Time

- 3,800,000:1 Dynamic Range

- Very High Sensitivity ? Ideally Suited for Operation Behind Dark Glass

- Maskable Interrupt

- Programmable Upper and Lower Thresholds with Persistence Filter

- Power Management

- Low Power ? 2.5-uA Sleep State

- 65-uA Wait State with Programmable Wait State Time from 2.4 ms to > 7 Seconds

- I2C Fast Mode Compatible Interface

- Data Rates up to 400 kbit/s

- Input Voltage Levels Compatible with VDD or 1.8 V Bus

- Register Set and Pin Compatible with the TCS3x71 Series

- Small 2 mm*2.4 mm Dual Flat No-Lead (FN)


PINOUT:

LED = LED control input. Leave floating for LED always on. Pull LOW to turn LED off

INT = Interrupt output active LOW. Output is open-collector so requires pull-up resistor. Connects to an interrupt input on the uC if used.

SDA = I2C SDA line. Connects to SDA on uC

SCL = I2C SCL line. Connects to SCL on uC

3V3 = 3.3V output from the on-board 3.3V regulator

GND = Ground connects to ground on the uC

VIN = Power input. Connects to 3.3V or 5V on the uC


Package included:

2* TCS34725 RGB Color Sensor





LTC
Reviewed in the United States on April 15, 2023
After 10 minutes of powering with Arduino NANO attached, LED started flickering and then went out. Still getting color readings from sensor but can't use in my application without LED. I only tried with one of the sensors ordered.