Your cart is empty.
Your cart is empty.Dave Johnstone
Reviewed in the United States on February 15, 2024
These are excellent boards for small thru hole prototypes.
Ellie
Reviewed in the United States on September 7, 2022
All the boards are tetrised into a single box. I wish they would have made it a little more use friendly and more easy to access the specific board you needed, but, i purchased a number of board, and got them in working order, so i'm happy.
Pierre
Reviewed in the United States on June 15, 2021
Good
Chris
Reviewed in the United States on March 3, 2021
this are very nice boards.
Mis. Horn
Reviewed in the United States on March 3, 2021
Now as a person who needs these quickly for a project in class they will do. Some boards have cracks. Nothing is burned. Honestly looks like wherever they were kept was just too cold for the boards. Little bit of white residue on the copper of them too. No green corrosion. Dependent on the size the thickness varies between the boards. They are your typical Prototype board. No more no less. They will get the job done.
Blake Christensen
Reviewed in the United States on October 31, 2021
Thin and fragile. Printing is rubbing off, or never adhered in the first place. These boards are literally falling apart, and leave a dust residue where they have been worked on. Holes are not lined up, and are inconsistent along the board. Finally the copper pads delaminate with the least bit of heat.Even as a practice board for soldering, you would be better off with a prototyping board that behaved more like a real board.
Joel Styer
Reviewed in the United States on January 24, 2021
I needed some larger proto boards for some testing I was doing. This looked like a great deal for what you get for the money. And it was. However, the board material is thinner than the usual 060 mil/1.6mm but still reasonably rigid. I can't remember now if it was 040 or 050. They other two things to note are 1) there isn't any solder mask so it is easier to bridge pads when soldering (but again, quite usable) and 2) the pads are bare copper so they may need to be cleaned before soldering with something like very fine steel wool or Scotchbright. The board are all reasonable flat with a minimal bowing even for the larger ones.
Gary Williams
Reviewed in the United States on January 27, 2020
I'm happy with the quantity and assortment of board sizes. They work just fine for my purposes.
Recommended Products
