Your cart is empty.
Your cart is empty.Product Description
Item Description
Specifications
- Capacitor Size: 250V 220UF
- Hole to hole on center: 3 13/16 inch / (97.2mm)
Wires
Totally 6 wires, 4 wires in one connector and 2 single wires
Fitment
AVR for 3500W Max Wattage Generator driven by 168FA 168FB 170F 5.5HP 6.5HP 7HP Gasoline Engine
Carmen
Reviewed in the United States on September 2, 2024
Product was prompt and exactly as described
Vernon shea
Reviewed in the United States on March 7, 2024
It works but only puts out 108volts A little low
Belcher
Reviewed in the United States on February 16, 2024
It was inexpensive to try and it worked. The generator working and used a lot.
Kenneth Young
Reviewed in Canada on February 15, 2024
Haven't use it yet, but looks like good quality.
LRZ - POZ
Reviewed in the United States on February 13, 2024
Worked great for me & what I needed it for
Customer
Reviewed in Canada on November 10, 2024
Pleasantly surprised, easy-ish install (7mm sockets required) Champion generator 3500wGood product so far.
Guillermo A.
Reviewed in Mexico on November 1, 2024
Se quemó a las pocas semanas de haberlo comprado
Customer
Reviewed in Canada on October 10, 2024
Boxes
Reviewed in the United States on January 28, 2024
I'm always hesitant to buy very low priced parts but this fixed my problem and seems to be working fine. I'll buy another Soo. Just to have as a back up. I live in Florida and it's a necessity to have a portable gen ready to go.
Douglas McNaughton
Reviewed in Canada on January 20, 2024
Just what I needed
Elton
Reviewed in the United States on December 13, 2023
The media could not be loaded.
J. Wade
Reviewed in the United States on November 18, 2022
Found a generator in a trash pile and brought it home to see if I could get it going. I got the engine going relatively easy, but it would not output full voltage. I did my diagnostics and determined the AVR was bad. I found this one and it was affordable, so I decided to give it a shot. The part was easy to swap out and fit perfectly in my application. The only problem I had was that the voltage was still not 100% so I had to adjust that on the AVR. Once I got the voltage adjusted, I put it all back together and it has been working fine since. I forgot to do this review, so it has been a little bit and has been used a little bit.
Matthew S
Reviewed in the United States on April 28, 2021
Perfect fit for Champion 3500 (Honda clone)You really need a multimeter though to complete install. First you need to set the meter to Hz and dial the governor screw on the motor to get to about 60-61.5Hz. Then switch to volts AC on the multimeter and dial the Blue potentiometer clockwise on the AVR (the piece being reviewed ) to move voltage up to 120v.You need a very small screwdriver for the potentiometer
Recommended Products
$27.00
$ 13 .99 $13.99