Shopping Cart

Your cart is empty.

Your cart is empty.

3D Printer DIY Inductive Probe PL-08N2 Inductive Proximity Sensor Switch Detector PL-08N Bed Leveling Probe NPN NC DC 6-36V 300mA Compatible with VORON 3D Printer

4.6 (9) Write Review
Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock
  • Demensions: 17x17x35mm, cable length about 2 meters, DC type NPN NC (Normal Close). Detection distance: 8mm +-10%
  • Supply Voltage: DC 6-36V; Current Output : 300mA; Detect Object : Iron 18x18x1mm
  • ABS material detection surface, the built-in intelligent sensing chip of the proximity switch can sensitively detect objects and with LED red light for output indicate.
  • The load of these switches connects separately with the power supply, owning the functions of the polarity, short-circuit and over-load protection, the residual currect can be neglected.
  • Voron 3D printer is using this type proble for their bed leveling. and It is also widely used in automatic control industry for detecting, controlling, and contactless switching. like mechanical automation, 3D Printer Probe Bed Leveling, and laser cutter


Package: 1piece PL-08N2 probe


Adam Lay
Reviewed in the United Kingdom on August 20, 2023
The tolerance is too high for this to be useful in creating a bed mesh with a 3D printer which is its advertised purpose. Have had to set my tolerance to at lease 0.05 and the bed mesh comes out different every time!
furball
Reviewed in the United States on August 15, 2023
Complete waste of time and Amazon's stellar return policy wants me to drop it off or return it which wastes even more time
Darren B.
Reviewed in the United States on January 4, 2023
I bought this with plans to convert my 3D printer to an inductive probe Z-stopIt sat on my shelf for a while - but finally installed it this past week.Worked great for the first few days. Not even 50 hours of print time (within a week), and it is dead.Guess it was a learning experience... If it had lasted, would have been thrilled with it.
Quinn D.
Reviewed in the United States on April 24, 2022
Light would look like it triggered but the voltage readings were wayyyy off. Caused the probe to not work at all. Do not recommend. Went with a uxcell PL-05N and it works flawlessly.
Adam Pierson
Reviewed in the United States on August 14, 2021
Failed Triggered after 5 min.
Daryl K.
Reviewed in the United States on June 21, 2021
Voron 3d printer, would not buy again
Jennifer Leach
Reviewed in the United States on February 11, 2021
I only had this in use for about 30 hours of printing before the first wire broke inside the harness. After replacing the wire and running another 10 hours, it ceases to trigger. Won't buy again.
BigD61
Reviewed in the United States on December 6, 2021
My needs are not for 3D printer. Used to sense door latch in locked position.Output pin is LOW when sensor is NOT active and Hi (open) when sensing metal. The sensitivity is as specified 8mm with 6 - 12 volts Vcc. This module does operate at 5 volts however trigger point is 7mm.
Dr. Darin
Reviewed in the United States on November 2, 2021
Never worked right out of the gate. It just stays closed (TRIGGERED) or opened (open) no matter how I configure the software. These things are not very smart, so it just has to be a bad sensor, but I don't think I can return it because I cut the cord pretty short.DO NOT PURCHASE - it's CRAP!