Your cart is empty.
Your cart is empty.4" Aluminum "U" channel barrel vise jaw pads will hold upto 3/4" diameter barrel or shaft and smallest is .4" diameter.
propbuildervash
Reviewed in the United States on September 11, 2024
Needed to replace a muzzle device. Due to the way the gas system was designed needed a solid and reliable clamp to prevent damage to the gas system. This clamped onto the barrel and allowed me to remove the muscle device and install the new one without applying any torque two parts that should not be torqued on.I shimmed with green painters tape to prevent marring the barrel. Thin leather swatcheswould also work well and would be highly recommended for dealing with any sassy muzzle devices.
LAT
Reviewed in the United States on May 2, 2024
A few inches of duct tape keeps them stuck to my vice jaws while working.
Sally A.
Reviewed in the United States on November 15, 2024
holds the barrel very secure.
Mustang Gregg
Reviewed in the United States on January 16, 2024
They work very well.
Ian B
Reviewed in the United States on March 28, 2023
This grips an AR bbl VERY well. Just what the dr ordered.
D. phillips
Reviewed in the United States on April 22, 2019
I used it remove a flash hider I blued lock tighted on a barrel. The upper in the configuration I had it in could not be supported by the receiver. I had to support and grip the assembly from the barrel. I did use scrap leather I had to line the jaws when I gripped the barrel. The leather lined jaws worked. It was an economical solution to problem. Item is well made and reasonably priced.
Rj
Reviewed in the United States on August 5, 2017
Was just slightly too long to fit between gas block and flas hider but clamped up behind gas block an worked great. Locked barrel up tight so i could change the muzzle device.
Juston B.
Reviewed in the United States on June 27, 2016
These do the job fairly well. I wish they were a little shorter. They nearly cover the front sight post and muzzle device of an AR. I cut a small section of water hose to insert inside the pads to help 'fill in the gap' between the muzzle device and front sight post. Otherwise, all that would be receiving the clamping pressure there were two small tapered areas that made me a little nervous.
Recommended Products
$84.42
$ 37 .99 $37.99