Your cart is empty.
Your cart is empty.Product Description
Specifications:
The brushless motor speed control is fit for DC brushless three-phase Motors without hall sensor;Rotation Control: equipped with control wiring, can control forward or reverse motor rotation;Speed Control Function: this controller module is with controlling switch, convenient to regulate the motor speed;Over Current Protection: the motor controller module is designed with over current protect, will be shut down the module and no output if over current.
julian romero
Reviewed in the United States on March 26, 2022
Es algo delicado pero funciona correctamente a 24 v genera duda
EDWARD
Reviewed in Canada on January 4, 2022
It was delivered as advertized.
Joseph E. Bradshaw
Reviewed in the United States on September 9, 2021
Work pretty good as a manual control board, but only with the hall effect sensors attached. I have not tried to implement PWM speed control yet. Pretty good board for the $.
Edward Ramirez
Reviewed in the United States on June 6, 2021
Didn't work at all
Alex Karpishin
Reviewed in the United States on March 1, 2021
Ordered because it is a clear statement in description:for DC brush less without hall sensor three-phase motors,Received ZS-X11B- after some searching found about ...B stand for Motors with HALL Sensor.Can't make it work in my case at all. Returning. Recommending to seller make more accurate description orat list some info how to connect. Not happy with my lost time :-(
Denys
Reviewed in Canada on January 31, 2021
Peace of scrap. Ordered 2.1 died immediately after powering. Second was died in 10sec after. Both have problem with in->15v stabilization which is lm317.
Victoria Orozco
Reviewed in the United States on September 1, 2020
Product came out defective. Per my father who I ordered it for, he stated the wiring was not done right.
Brad
Reviewed in the United States on March 23, 2020
Couldn’t get this to function at all.
vince
Reviewed in Canada on February 3, 2020
this is obviously from another assembly, likely removed from junked equipment. No documentation, Chips have been obfuscated by sanding off the part numbers so you cant even figure out how it works. Total junk.
WALLBANGER
Reviewed in Canada on January 17, 2020
unfortunetly i received the product defective or bad design , no mounting holes to secure the unit in place would have used it for my cnc router
Recommended Products