Your cart is empty.
Your cart is empty. Product parameters:
The module supply voltage 2V-10V.
Signal input voltage 1.8-7V.
Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
Product size: 24.7 * 21 * 5mm (length, width, height), ultra-small size.
The mounting hole diameter: 2 mm.
Attention:
1. Power positive and negative reversed will certainly cause damage to the circuit.
2. Output is shorted to ground or output short circuit, and the motor stall, the chip will heat protection, but in the near or exceeding 10V voltage and peak current is greater than 2.5A situation can also cause chip burned.
Package Included:
6 * Mini L298N Motor Drive Module
Bruce Berg
Reviewed in the United States on December 2, 2024
Works as noted. Very small circuit boards. I needed a very small motor controller for a project I am working on. These fit my need.
Carol G.
Reviewed in the United States on January 4, 2023
Wanted a mosfet version but those are apparently scarce as hen's teeth atm, so I had to settle for one that's transistor based. There's a couple of volts dropped because of that but I'm running 6v motors on them just fine.
Raw means I love you in dinosaur 🦕
Reviewed in the United States on January 25, 2021
Great
Recommended Products
