Shopping Cart

Your cart is empty.

Your cart is empty.

85mm Marine Tachometer Gauge 8000 RPM with Hour Meter for Motorcycle Car Truck Boat Waterproof RED Backlight

Free shipping on orders over $29.99

$29.99

$ 13 .99 $13.99

In Stock

1.Color:White


About this item

  • Be suitable for all kinds of tacho RPM sensors, and display the rotation speed of the engine,the engine must has pulse signal.
  • Use moving-magnet principle to drive the needle, featuring good endurance and anti-vibration.
  • IP67 waterproof , rainproof, dust proof , anti fogging,Indicating Range: 0-8000RPM
  • If your motor has no speed sensor , please purchase one separately . It is better to use with speed sensor, don't directly connect the gauge to trigger coil. Here are two different size of speed sensor in our shop M16 and M18 , Please choose the right size.
  • The tach pick up it's signal from DC Generator, it could not work with alternator


Feature:
-Fixing dimension: 85mm(3-3/8")
-Indicating Range: 0-8000RPM
-Speed Ratio: 0.5-250.0 adjustable
-Working Voltage: 12V/24V
- Red backlight
-Operation mode: LCD display, stepper motor
-Protection grade is IP67, the whole body is completely waterproof;
-Excellent anti-fogging function;
-316 Stainless steel bezel with curved glass;
Come with:
1x GPS Tachometer
1x Power cable
1x Installation Instruction


Bee K.
Reviewed in the United States on March 31, 2024
Directions was translated from someone not very fluent in english and was not very clear. I didn't need it but thought I point that out. The gauge is nice but didn't work as it's supposed to.. The gauge setting did not respond to any settings no matter what I chose to set it at. Was not reading accurate. Sometimes you get what you pay for. I ended up tossing it away and spent more money on a proven brand that did work properly.
Pedro raad
Reviewed in the United States on November 28, 2024
Espectacular
gregory l barron
Reviewed in the United States on September 8, 2023
This tach is slow to respond, jumps all over the place and cuts out regularly after only 50 hours use.
ryan
Reviewed in the United States on June 16, 2023
Hook this up on my Seafox 160 with a 50 hp mercury two stroke. It was an exact fit for the old rpm gauge that did not work so I tried this one. I can’t get it dialed in properly. I follow the instructions. Mine is a 12 pole therefore it needs to be on setting three according to the instructions, but then it says my idle is at 2000 RPMs and when I’m cruising I’m at 8000 RPMs I’ve tried all the settings nothing is even close to being right and you have to come down to idle to get the rpm gauge to drop back down from the highest that it reached. So it doesn’t work it’s cheap.
old texan
Reviewed in the United States on August 10, 2022
Tach is working great so far. Easy install
Tina Geary
Reviewed in the United States on July 6, 2022
I would like to have it if I knew it was going to work. To much trouble to cut out holes in my new dash and hook it up. 70 / 30 chance it won’t work. If you would like to have me try it and give an HONEST review I would then. Only Way
Michael Kackritz
Reviewed in the United States on March 27, 2022
It doesn’t work,I bought it for a Mercury marine 200 HP 2 stroke and wired it up and it doesn’t seem to work.
Clayton
Reviewed in the United States on November 30, 2022
Installed guage on a 1978 camaro v8 and guage needle is bouncing when engine is smooth, sensor wire is going to tac plug on distributor cap and is free of high current lines any solutions?