Your cart is empty.
Your cart is empty.Typically used in the automotive aftermarket for sanding putty. Can be used for any application where removing material is desired.
Thomas Francis
Reviewed in the United States on December 12, 2022
Good value for your money
Hunter Collision Consulting&Equipment Sales
Reviewed in the United States on October 16, 2022
Price is fair.
Josiah F.
Reviewed in the United States on July 20, 2021
The grit covers maybe 1/3 of the surface and starts to fall off immediately. Completely wasted money. Do not buy.
Keith
Reviewed in the United States on November 7, 2021
Surprisingly lasts a long time. Sanded paint off a car and used to knock down lots of body filler
Terry Smith
Reviewed in the United States on August 16, 2020
Probably fine if you have a brand new sander back of disk not fuzzy enough for good attachment if you lift the sander Up you have a flying disk
Jadia L. Ward
Reviewed in the United States on November 22, 2020
OK, was nervous ordering these, but was looking for cheap, for a non-critical application . I used with a D900 to clean off a particleboard floor in a dove loft prior to epoxy coating, so a bunch of dove poop, and a bit of particle board. Figured the discs would load up pretty quick, so went for quantity over quality. Adhesive pattern is pretty spotty, grain size not really uniform, but they held well to the pad, released cleanly, really did not load up, and held up well in this use., I got about 15 sq feet per disc. Would buy again, and will try in a more demanding use.
minerva mink
Reviewed in the United States on July 8, 2018
learned my lesson the hard way..dismal quality, the adhesive tends to "let go" very easily, the grit is spotty at best with rather large voids...i was hoping for some reasonable quality compared to dura gold or mirka ...instead its bargain basement garbage
dougbiggs
Reviewed in the United States on September 1, 2017
seems to wear out on edge a little faster than others, but for the price work good
Recommended Products