Your cart is empty.
Your cart is empty.Includes 9 pieces of cables (2pin*1, 3pin*1, 4pin*2, 5pin*1, 6pin*2, 7pin*1, 8pin*1)
Elgin
Reviewed in the United States on March 20, 2025
These were a great fit for my JK BMS "GPS" port which is really ttl serial data out.
Marko
Reviewed in the United States on July 11, 2024
cables pin-out not appropriate for PX4
Niro
Reviewed in the United States on April 27, 2024
Bought these to replace a receiver firmware upgrading cable for my fpv drone. The individual wires allow for easily switching which wire to which port. They fit great and worked just how I needed and I am happy to have a some in case I need them again.
Michael B.
Reviewed in the United Kingdom on December 22, 2023
Connects my MMWave sensor to my home assistant with out an issue.
Leen
Reviewed in the United States on April 5, 2023
I bought this to use with the mRo Pixhawk flight controllers, per the product description. The connectors did not fit.
jeffd
Reviewed in the United States on April 12, 2023
I bought these cables to connect to a tiny motion detector board with 1.25mm pitch square pins. Clearly, these connectors were designed for round pins. I was able to force the connector onto the square pins, but it is far from ideal.
sharkeysharkdog
Reviewed in the United States on February 15, 2022
Works Great!!
Razor
Reviewed in the United States on June 29, 2020
These are very handy cables! These are JST-SH connectors. They are NOT the ones that plug into Pixhawk ports. They are mainly found in external sensors, like GPS. They terminate to female 2.5mm jumper pins.
pahlabi
Reviewed in the United States on December 21, 2020
good
Recommended Products
