Your cart is empty.
Your cart is empty.part number: 904949. Package Includes: Overhaul Kit, as the picture shows. Compatible with Porter Cable FN250B Type 1, FN251 Type 1, Nailer Parts. handy kit makes an overhaul repair of your FN250B FN251 Nailer fast & easy. These parts install quickly to make your nailer work like new again. A brand-new, unused, unopened, undamaged item in its original packaging.
Book scout
Reviewed in the United States on February 19, 2025
I bought this to replace the original component which had started leaking. This replacement part doesn't leak. However, within a week it stopped working properly. The nailer will not fire with the red trigger installed, but it will fire if I remove the red trigger. (I ordered a replacement red trigger to try to isolate the failure, but that did not fix the problem with this valve.)
Customer
Reviewed in the United States on August 8, 2024
Correct kit, fit fine.
Judy Stephens
Reviewed in the United States on August 2, 2024
not all seals encluded
psolla
Reviewed in the United States on December 28, 2024
Replaced the trigger valve with this one because my FN250A nail gun hissed air when connected to my air compressor and would not fire. After replacing the valve my nail gun it fired 3 times and the valve stuck open hissing air and would not fire.
Delray
Reviewed in the United States on October 31, 2024
The rebuilding went quickly.
Mike woods
Reviewed in the United States on April 5, 2024
Promptly shipped, arrived as described and worked perfectetly
donald n berger
Reviewed in the United States on April 29, 2024
it didnt even have the only oring i needed so my nail gun is still not working
D Dubb
Reviewed in the United States on August 12, 2022
Almost everything, 1 major peice that always breaks and should be part of this kit but is not Advice Shop around the complete kit is available at the same cost. My mistake don't make the same.
Recommended Products
$28.75
$ 14 .99 $14.99