Your cart is empty.
Your cart is empty. ➤Fitment for:
For select models of Jeep, Chrysler, Dodge, Ford, Chevy, GMC, Lincoln, and Cadillac;
➤Package Include:
2 pcs ABS Wheel Speed Sensor Connector Pigtail
with 4 pcs Heat Shrink Connectors
➤ Replace Part Number:
645-134
S-1895
19352068
3U2Z14S411BXAB
5183448AA
68065018AA
➤ Specifications:
2-way wire
18 Gauge Tinned Copper Wire
12 inches / 30 cm Length
Customer
Reviewed in the United States on March 29, 2025
Cheap quality
Black Iron
Reviewed in the United States on March 17, 2025
Excellent replacement plug/pigtail for a 07-18 JK rear ABS sensor. Needed to repair a broken/smashed wire on my right rear. Removed the wiring from the wire loom and was planning to splice the broken wire but noticed the connector would not stay on the sensor due to damage from removing it. Found this pigtail and it is a direct fit. Both wire are black, but it doesn't matter which you splice into on the vehicle. I was able to extend the harness and keep it from being smashed in the bump stop.
BC in SB
Reviewed in the United States on February 24, 2025
I was getting a traction control error every time I went over a seam in pavement or when I hit rough washboard roads, so I knew I had a bad ABS sensor. Unfortunately when I replaced it the red plastic clip broke off (as they often do. I clipped them off close to the connector and spliced these units right onto the wires and used the included butt connectors to crimp everything and then used a heat gun to shrink the insulation. They worked perfectly. The only negative is that the wires on these replacement connectors is slightly stiffer than the OEM wire (the plastic on the insulation is a bit stiffer) but I don't think that will affect the performance. I also added some additional heat shrink tubing over the entire connection to give it extra strength, since I use my Jeep off road a lot on very rough trails (lots of washboard in the desert).
Recommended Products
