Your cart is empty.
Your cart is empty.Product Description
NOTE:
- Only fits models with MANUAL AC controls
- Only Fits Vehicles with 2 Bolt Mounting Flange on Factory Resistor.
- Only fits models with MANUAL AC controls and without rear A/C vents in the center console.
AC Blower Motor Resistor Harness With Harness and Instructions
Installation Instrution：
- Locate the Blower Motor Resistor
- Disconnect the Wires
- Take out the Blower Motor Resistor
- Install the New Blower Resistor &Wire the Pigtail
Package Include:
- 1 PCS Ｘ AC Blower Motor Resistor
- 1 PCS Ｘ Wire Harness
- 1 PCS Ｘ Gloves
- 1 PCS Ｘ Installation Instructions
- 6 PCS Ｘ Heat Shrink Crimp Connectors
NOTE:
Only fits models with MANUAL AC controls and without rear A/C vents in the center console
OEM Replacement
- Replacement for 89019088
- Replacement for 973-405
- Replacement for 15-81086
- Replacement for 22807123
When do I need to replace the heater blower motor resistor?
When you encounter the following situations:
- No air blowing out from the vehicle vent
- The blower motor only operates at high speeds
- The blower motor only operates at low speeds
- The blower motor does not operate under certain settings
- Continue blowing when the air conditioning is turned off
- Smoke emanating from the vent
- There is an unpleasant burning smell
- Fan cannot close
Wise shopper?
Reviewed in the United States on March 10, 2025
Worked
BL
Reviewed in the United States on October 10, 2024
Worked out great. Had to wire it in but working well for the speed control.
Customer
Reviewed in the United States on August 30, 2023
Fit my truck as described
Crannman
Reviewed in the United States on June 12, 2023
I thought it was the resistor going out because of the way the blower motor was acting. It wasn't. It was actually the blower motor itself....but I'm going to keep the old resistor as a spare because of the prices on everything going up
Jay
Reviewed in the United States on May 14, 2023
I had no issue installing and I was hopeful that the description was accurate with respect to the claims of being a better quality and able to compensate for GM's original poor design resulting in overheating/burning. 2 pins had melting around them so as expected I lost speed 4 and then ultimately all power to the blower.I have also replaced the blower previously so there is no question the resistor and replacement harness quality are the issue.
oldgunslinger
Reviewed in the United States on December 29, 2022
So far the part is working great. First one died almost immediately.
Ron S.
Reviewed in the United States on April 17, 2022
Correct for 2007 Tahoe with dual zone controls. These fail from overheated power connections. Fortunately this comes with the replacement plug connection. Because of that, you will need a good quality pair of crimping pliers to do this installation correctly or you will have hot connections in the future. This product took care of my circulation fan operation and I highly recommend it.
toby
Reviewed in the United States on April 25, 2019
So far so good. It's nice to have cold air in the Texas summer
Recommended Products