Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 509-Dark Olive Green 80/20 Loop. Other colors and materials may be available in the selection above.
- This aftermarket carpet is a replacement for 1968 to 1972 Chevy Chevelle, 2 Door Automatic.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1968, 1969, 1970, 1971, 1972, 68, 69, 70, 71, 72
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point on both driver and passenger sides. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
Jason
Reviewed in the United States on June 24, 2023
I love the fact that this setup came with the JUTE under padding glued to the underside of the carpets, the rich deep dark black color is fantastic with the white contrast in my interior of my 1971 Chevelle. The Drivers side floor heel pad is VERY thick and will NOT wear out any time soon. Should be able to get 20 plus years out of these carpets. They burn easily for seat and seat belt holes and are molded to the floors, so they fit really well. Extra materials on the sides so you can ensure a good clamping from the aluminum sill moldings and if you wish, a few squirts of spray adhesive will ensure the carpet stays still in those few little spots like around the foot wells in front and rear seats, if you want, you can squirt the underside for under the rear seat to make sure its nice and tightCost = Great bang for your buck, Fit and finish = Really well done. Coloring = Really a deep dark black color not gray-ish looking or charcoal its black as night. Soft as auto carpets can get I guess. Not like new 2020's style car carpeting, this is old school loop carpeting so it looks exactly like it did from the factory. I am very happy and the cost was very fair. There are less expensive by a few bucks but this with the factory Jute padding made the few dollars more worth while.Hope this review has helped you with your choices and best of luck with your auto interior projects!!!
Andrew Young
Reviewed in the United States on February 5, 2021
Perfect fit with a slight trim a the rocker panels.
Recommended Products
