Your cart is empty.
Your cart is empty.
Fitment:
Carburetor carb repair kits replacement for Johnson Evinrude V-4:
85hp 1969-1979
85hp1991-1993
88hp 1985-1995
90hp 1981-1983
90hp 1985-1995
100hp 1971-1972
100hp 1979-1980
115hp 1969
115hp 1980-1995
115hp (Except 60 Looper) 1995-2002
125hp 1971-1972
135hp 1973-1976
140hp 1977-1983
replacement for Johnson Evinrude V-6 Crossflow:
150hp 1976-1990
155hp 1979-1990
175hp 1977-1991
185hp 1984
200hp 1976-1983
235hp 1978-1984
Note:
This picture is of the actual kit you will get
Please compare it to what you need to make sure it is the correct kit for you
Ed
Reviewed in the United States on June 23, 2024
Gaskets and o-rings all fit. The seat had different threads. 115hp johnson outboard.
michael s mitchell
Reviewed in the United States on October 22, 2024
Boat is back on the water
Gene Rousculp
Reviewed in the United States on December 24, 2022
Had all the parts needed. It appears to be a universal since there were some parts that were not needed for my rebuild
George C.
Reviewed in Canada on November 18, 2022
Most of the items in this kit is Junk. I purchased this and the only thing I could use were the gaskets. The needle seat was poorly machined and wound not screw all the way into my carb. Save your money and purchase a brand name kit.
Keith
Reviewed in the United States on September 9, 2021
The gaskets and o-rings were a good replacement. The float valve seat didn't match original threads so I couldn't use it, but the new float and pin works with the old seat just fine. Most parts that came with the kit weren't for this particular carb, but a full rebuild was possible with this kit.
Jim brown
Reviewed in the United States on June 9, 2021
Float seats were wrong thread size. Orange bowl gaskets are not gas resistant. Fuel ate the gasket and leaked contamination into bowl ruining the carburator. (X2)
Brian Collins
Reviewed in the United States on May 30, 2021
I needed to open the carbs back up and this is what I was greeted to. Original gasket is on the right. The needles and seats don't fit. The threads are wrong and so is the depth. Only useful bits was the orings, floats and manifold gaskets. Pretty much a waste of money.
Michael Jones
Reviewed in the United States on November 25, 2021
Gaskits split and disintegrated, carb leaked gas everywhere. Never buy again. Garbage
Charles
Reviewed in the United States on June 14, 2020
I used this for my Johnson 115 hp carburetor rebuild project. The seats that came in this kit would not thread into my carburetor, I had to re use my old stuff. I installed the needle and new gaskets and O rings on fuel bowl drains. The floats looked right also, however there was a lot of stuff I discarded in the kit, maybe stuff for various models. Bottom line is that I would not purchase again, try and find a kit made in USA or at least a known brand. ( after 1 season I had to rebuild again due to inferior gasket material ! )
Recommended Products
$32.99
$ 15 .99 $15.99