Your cart is empty.
Your cart is empty.Heavy-duty, 27 degree, 6-blade fans, available with aluminum or steel blades, can move the volume of air needed to keep race engines cool. Universal bolt pattern with a 5/8" pilot hole.
Dorian Swenson
Reviewed in the United States on September 21, 2024
Worked fantastic in my 72 roadrunner, 340 engine.
Monty S.
Reviewed in Canada on August 22, 2024
I purchased this very well made steel fan for a classic car. I removed the 15" clutch fan with 4 blades. Upon easily adding this 17" 6 blade constant turning fan I had immediate reduction in heat!!
Al Miller
Reviewed in the United States on June 3, 2024
The fan is described as an “18” diameter fan when actually the true diameter is only “17” when measured with a standard measuring device.
William Hevey
Reviewed in Canada on March 1, 2024
Came in a big box , fits perfectly, paint is very good
Mario Brideau
Reviewed in Canada on February 4, 2024
Restauration d’une voiture antique
Customer
Reviewed in Canada on January 26, 2024
Good product fast shipping
DJN
Reviewed in the United States on August 3, 2023
Putting on my pontiac GTO. Feels well built non flex fan what I wanted.
Rodolfo Gonzalez
Reviewed in the United States on May 13, 2023
I got this for my Vermeer wood chipper with a Ford Inline 6. Onan generators also have these great old Ford engines. This fan pulls air through the radiator shroud over the engine, if you're facing the engine front, it turns clockwise. It has good pitch, sturdy, and no whiny noise from bad design. This is a great value. Previous owner put the wrong blade on, and overheated, blowing hot engine air into the radiator. This will draw cool air through the radiator and fan the engine. Make sure you measure from the middle of the shaft to the shroud, and multiply by two. You should end up with ¾ of an inch or so. Mine was the 18 inch blade. I hope this helps everyone else with the same dilemma
Tyler R.
Reviewed in the United States on August 30, 2022
Run this in our 602 crate engine/350 small block race car, fit and works awesome!
clay Huckins
Reviewed in the United States on August 5, 2021
great quality power coated i am sure, great fit and priced well below auto parts stores in area
Leslie Clingerman
Reviewed in the United States on December 25, 2021
Very good figment and good quality. Looks great on engine
Brassard mario.
Reviewed in Canada on December 27, 2020
Hot rod
Shelby
Reviewed in the United States on October 3, 2020
I installed this on my 1962 Buick Invicta that are known for cooling problems. It certainly helps move the air through the radiator. It also is a good value and good quality.
Recommended Products
$21.88
$ 10 .99 $10.99
$26.84
$ 11 .99 $11.99
$80.55
$ 33 .99 $33.99
$105.99
$ 50 .99 $50.99