Customer
Reviewed in the United States on July 4, 2024
Holes within pivot balls was 0.3mm too small, and would not fit on the front uprights. Replaced them with spares from my parts box. When adjusting the turnbuckle, the screw sheared off. Now totally useless so I will get a better quality product elsewhere.
Erica Marko
Reviewed in the United States on June 15, 2024
The front arms lasted one crash. Both bent. Rears are still straight.
martin
Reviewed in Canada on November 9, 2024
Ça te prend ça merci
Spc123
Reviewed in the United States on July 19, 2023
They seem sturdy, but this design is poor poor poor.Make sure you look at the shaft because there is a slightly deeper groove made for the smaller ring. Regardless, the smaller retention clips need the inside dremeled out or you'll snap them. It's fascinating they have grub screws to hold the turnbuckle in place, but not the shaft... so if you don't have extra clips, you won't be able to disassemble/reassemble if you need to change something out.**reccomendation**(manufacturer, pay attention)If you have the ability to drill and tap grub screw holes, save yourself the frustration and just do what should have been done originally if the manufacturer had even a slight a bit of forethought and sense of uniformity..
Green
Reviewed in Canada on December 14, 2023
The adjustable upper suspensions arms are a geat upgrade because the adjustments are handy.
Shaun K
Reviewed in the United States on December 1, 2023
The media could not be loaded.
Danny
Reviewed in the United States on December 18, 2022
So the front fit just right no real issues, but the rear c clips that hold the pins do not fit and broke all 5 of them