Your cart is empty.
Your cart is empty. JQF Gear Anti Fog Insert Pin for Motorcycle Helmet Universal for Pinlock Insert Pins
About Anti Fog Insert Pin:
- For universal motorcycle helmet visor with pin locking holes.
- Package: 1 pair anti fog pins.
- Three Styles of Pins: PUSH PIN/ Three OFF PIN/ TEAR OFF PIN.
Please check the pictures for recommendations and select the appropriate pins for your lenses.
- Available Helmet Peak Shield:
JQF Gear peak visor fits 3/4 vintage open face helmets and half helmets with 3 snaps.
For CustomerIf :
you are not sure how to choose the pins, please contact the seller and provide the picture of your lens with the model number, we will contact you and help to solve in 24 hours.
michael
Reviewed in the United States on January 7, 2025
does not keep from foging up
Joseph Campbell
Reviewed in Canada on August 30, 2024
My helmet (FreedConn BM12) is basically a no-name brand that isn't listed on the Pinlock website and the despite a few hours of searching, I couldn't find a proper Pinlock visor for it. So I had to make due. I measured my visor and helmet opening to get the dimensions. I then picked a Pinlock lens that had dimensions that would fit inside. See the review on that below. Since I suspected that the lens wouldn't come with mounting pins, I ordered these. The part of the pins that hold the lens is round, yet the ends of the lens have square recesses. Simple solution was to use a sharp knife and carefully cut small V shaped notches at the middle of the square recesses. Even then, it was a judgement call on where to drill the holes in my visor. The portion of the pin that holds the lens is off-set and so I orientated it so that it was halfway between being oriented completely away and completely towards the lens. The off set is for fine-tuning, but there is no easy way to turn these pins once completely installed, despite the pins having a hex on the inside to accommodate a wrench or socket and despite the outside cap looking like it accommodates a tool of some kind, there is no turning it without risking damage. The only question I have is 'why is the outside cap so big and why is the spot where it attaches to the pin off center as well?' There is no need for it as I can see. Once screwed together and secure, it's too tight to turn. You install and remove the lens by flexing the visor and lens as necessary. I should also mention that the pins didn't come with any instructions. Thankfully I'm a little bit crafty and could figure it out.See my visor and lens reviews below:https://www.amazon.ca/dp/B0863C8CVFhttps://www.amazon.ca/dp/B00EPSDPVE
Dennis K
Reviewed in the United States on March 25, 2024
perfect fit, snug up nice and tight. watch the YouTube video to see how to properly change them out
Joseph Evans
Reviewed in the United States on December 3, 2024
I’ve ordered these a few times and they constantly are breaking off of my visor
jeremy
Reviewed in the United States on November 2, 2024
Works grate
tom
Reviewed in the United States on October 23, 2024
as advertised. fit well.
Did not fit shoei cw-1 face shield
Reviewed in the United States on April 12, 2024
Did not fit shoei cw-1
Recommended Products
