Your cart is empty.
Your cart is empty.AP Exhaust 700466 Muffler
T. Foreman
Reviewed in the United States on March 8, 2025
Its a decent cheaper option for a stock replacement. Its not as quiet as the stock muffler but it has a nice little growl to it. It comes with factory size pipe. Overall it works and now 6 months later its held up, still sounds the same so Im happy.
Nivaldo Danieletto
Reviewed in the United States on January 8, 2025
É o que eu precisava
Scott F
Reviewed in the United States on September 29, 2024
Muffler exact replacement was easy installed, functions and sounds good. Build quality looks good and for the price could no beat shipping was great received two days earlier then expected.
Yurky
Reviewed in the United States on May 29, 2024
Fit perfict !! Great price !!
alexander
Reviewed in the United States on October 29, 2024
Excelente calidad, no tuve ningún tipo de inconveniente al instalarlo, apto para Grand Cherokee Laredo 2005, por un lado tengo la foto de mi artículo nuevo ya adaptado y por el otro tengo el silenciador viejo de mi camioneta, lo compré con algo de miedo pero de verdad que cumplió con todas mis expectativas, espero que te haya ayudado mi comentario.
saha6818
Reviewed in the United States on April 23, 2024
The fit was fantastic. It slid snugly over the old pipe downstream of the muffler. I was tempted to leave it at that. But I had an exhaust clamp around that fit perfectly. So I didn't have to pull the rear part of the exhaust and weld it up. It didn't come with hardware, so I pounded the studs out of my old muffler and tried to use them again. But the stud holes were too small in the new muffler. Maybe have some nuts and bolts handy or even tack the nuts into the new flange for easy installation. I only drove the Jeep 60 feet since installing it, but the sound is fine. Maybe a little more muscley than the old muffler. I think it is a lot lighter.
Reggie L.
Reviewed in the United States on April 16, 2024
Installation tips: Additional items needed are two nuts and bolts for the front of the muffler and a 2.5" exhaust pipe clamp. The OEM final exhaust pipe is welded to the old muffler. If keeping it, cut it off close to the muffler. Then unbolt the muffler at the other end. Bolts may snap off but that is OK, they are not needed. The muffler may drop fast so look out. Slide off the rubber hanger that is next to where you cut the exhaust pipe, then slide the new muffler over the pipe. Reconnect the rubber hanger as you raise the muffler into position. Bolt front of muffler with new nuts and bolts. Place the 2.5" exhaust pipe clamp over the rear end of the muffler. Before tightening, make sure the rear pipe does not hit anything, such as the rear axle by rotating it. After tightening the clamp you are done!
loudv8
Reviewed in the United States on December 28, 2023
I bought a used 2010 Grand Cherokee on the cheap and the original muffler was long gone. I picked up this muffler for a fix, cut off the old one and this was a direct fit and quiet. I would highly recommend this muffler as a replacement for your blown out one.
Recommended Products