Your cart is empty.
Your cart is empty. Brand New Backup Park Reverse Object Sensor Pack Of 4
Compatible With All Rear Bumper Positions
Match Vehicle To Compatibility Chart To Ensure Exact Fitment
These sensors report back to the computer which causes a beeping sound when you are backing up and approaching an object. The closer you get the closer the beeps sound.
Replaces 15239247, 25961316, 20908127
⚠ California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Holly C.
Reviewed in Canada on July 2, 2022
Installed in my Chevy Avalanche that was displaying "Service Park Assist" warning. Broke one sensor trying to install. With 3 new sensors and one old sensor installed, the warning cleared. The sensors worked as I backed up the for the first few times. One week later, they are convinced there is something behind me so alarm every time I put the truck into reverse even though there is nothing there. I tried cleaning the sensors...no difference.
Charles
Reviewed in the United States on March 31, 2021
What I received were not brand new aftermarket sensors, but rather GENUINE GM SENSORS that were obviously USED (typical dirt and corrosion on/around the contacts) and PAINTED. Through the thin layer of black paint, I could see the original GM markings. I am happy with my purchase; all 4 sensors are working. I am giving four stars for 2 reasons - firstly, because they are advertised as brand new, and they are not; and secondly because the addition of the black paint altered the tolerance enough to make them difficult to clip into the harness by hand. I would have been happy to pay this price for "used tested functional OEM" parts WITHOUT any black paint added to them, and would have gladly given 5 stars.
james bell
Reviewed in Canada on December 28, 2021
No problem easy install work great
André Mathieu
Reviewed in Canada on January 23, 2021
Great product...direct fit!
Dave
Reviewed in the United States on August 14, 2019
They work like OEM. Granted I only needed one since that’s where my son plowed his bike. No issues though. The one I replaced was an outside sensor. I’m sure the inside ones are a little more difficult to install.
Matthew W
Reviewed in the United States on July 3, 2019
Worked great on my 07 Escalade EXT. Had service park assist on my dash and red indicator light above rear seats for back up monitor on. Determined that a sensor had went bad. Replaced all 4 and now the park assist message is gone. Working as it should. Would recommend to a friend.
scott
Reviewed in the United States on May 18, 2019
ONLY USED 1 SO FAR BUT NO ISSUES
GregoryK
Reviewed in the United States on November 14, 2019
They work great, were easy to install at a small fraction of the cost of going to the dealer. (2010 Chevy Avalanche)
Hines
Reviewed in the United States on April 29, 2019
Worked great, plug and play just like the OEM part. Great value over the parts store
Scott
Reviewed in Canada on April 25, 2019
Better than going to the local dealer by along shot. Great price and delivery
Carl R Dawson
Reviewed in the United States on August 3, 2018
2007 Tahoe. took the bumper off, installed a new OEM harness, and these. didn't work. tried disconnecting the battery, etc. and these still didn't work. So, i guess I will have to consider shelling out for the OEM sensors since it seems none of the brand-x on amazon work for people. These didn't work for me.
James M. Klein
Reviewed in the United States on April 10, 2018
I had one non-functioning sensor (you can tell by turning the key to the accessory position, shifting to reverse, then go back to each sensor at the bumper and listen for a slight clicking sound - Do not actually turn the engine on and shift to reverse, or you will run yourself over. Don't say you weren't warned!) Thankfully the bad sensor was one of the outside locations. The outside sensors on my 2010 Suburban are easily accessible from underneath the vehicle. The two interior sensors would probably need the bumper removed to some extent. But swapping out the old sensor for the new one was a five minute job in this case, including the time it took to clear out all the dirt and crud that had built up around the sensor (probably the reason the outside sensors fail more often). Now I don't get the "Service Park Assist" message on the DIC and the backup warning system is back to normal.
Recommended Products