Your cart is empty.
Your cart is empty.RAS1500
Reviewed in the United States on June 14, 2024
The quality of this product seems to be quite good, considering the price. I only used it once on my old 6 inch Craftsman lathe. It worked as intended.
Dallas
Reviewed in the United States on November 16, 2024
Small but handy when needed
Strom
Reviewed in the United States on January 12, 2024
If you need this you’ll know the grinding and spring strength are important. Both are done well.
Uncle Bo
Reviewed in the United States on April 21, 2024
Parts are machined with good finish, but unfortunately the spring loaded tip has too much play in the hole of the shaft. Although I haven't measured, I estimate the tip can wiggle at least 1mm. Perhaps good enough for casual rough work, but not good if you aim for precise centering. I might try to make a bushing to reduce the play, or possibly make my own tip part that fits tighter.
Matt W.
Reviewed in the United States on February 18, 2020
Very handy to have. Well made and of good quality.
Bennett Kauffman
Reviewed in the United States on March 27, 2019
This works really well! I've used it several times. Great tool!
Weld
Reviewed in the United States on February 23, 2019
Its ok but cheaply made. Pull it apart and sand it down with some fine paper and lube it a bit. Works ok after that
Seth Emerson
Reviewed in the United States on June 30, 2018
Used it twice already, worked fine.
Recommended Products