Your cart is empty.
Your cart is empty.Product Description
Terminal contact 3EA (applied 3wire:A, B, b).
Structure type without terminal head.
Protection tube(probe part) Stainless steel 304.
Fixxing thread Stainless steel 304.
Product Details
- Model NO.: MR2170-1/2-50 Element Pt100(platinum)
- Lead wire Insulation: teflon (with electromagnetic shield)
- Total length: 2080mm(6.82ft)
- Fixing thread PT1/2"(taper thread)
- Temperature range: Normal[recommend](-50~200)degrees, Max.(-50~250)degrees
- Protection tube(probe part) length: 50mm(1.96")
- Probe part diameter: 8mm(0.31")
- Lead length: 2000mm(6.56ft)
Kris A.
Reviewed in the United States on December 18, 2023
The ATOPLEE Temperature Sensor is a nice addition to my home brew pot. The probe itself is almost 2” log, allowing it to get a good sample of the water temperature without interfering with the contents inside. It also comes with prongs on the ends of the wire making it easier to hook up to my temperature controller. Finally, with 2-negative ends, it hooks up to two or three wire connectors easily.The only downside to this is that the temperature sensor does not come with a nut for the end. Overall, I am very satisfied with this temperature probe.
Robert Sanges
Reviewed in the United States on December 12, 2023
The RTD is as the listing describes. It's a 3-wire design which is most common but can be used on 2-wire or 4-wire systems with wiring/jumpers changes.The sensing head is one piece, so, if threading it into a fixture, remember that the wire leads must also be allowed to rotate.I tested it on an RTD calibration device and it was accurate to within 0.5 degrees F at room temperature.I like the strain relief and that lugs are attached to the wire ends.
FreeThinker
Reviewed in the United States on April 27, 2020
it does work but beware that the photos showing the wire identification is wrong. + is not the white one , its one of the blue. Once I realized this - i did do some testing with ice water and very hot water and the probe is very responsive I do like it.
Ata Goldberg
Reviewed in the United States on October 23, 2019
Purchased this for a replacement in a heat monitor. Traveled 4 hours to do the replacement and the probe was no good.
Travis Miller
Reviewed in the United States on June 21, 2018
Good so far and have stood up to 3000 PSI hot washer service.
M. Stolle
Reviewed in the United States on July 27, 2017
Threads are slightly smaller than standard NPT. This causes it to not seal properly sometimes. It is a very small deviation, but enough that it goes all the way in to a female NPT without binding, and may not make a water tight seal. No amount of teflon tape was able to fix it.Took another star off due to the stainless rusting with pitting and corrosion. Seems to be low quality stainless. However, for the cost it is still a good value at this price.
Customer
Reviewed in the United States on February 24, 2017
Works well. Runs on both my arduino and the temperature controller I previously got. Should work awesome for my fermentor temperature control plans.
Amish Country
Reviewed in the United States on July 22, 2016
I was looking for a sensor to go along with some of the low cost PID temperature controllers commonly sold on Amazon and Ebay to replace the K type thermocouple for low temperature accuracy. This did the trick. It is a 3 wire PT100 configuration which I missed initially not a 2 wire but that is better. The only thing I'm concerned about is the rather fragile looking lead wire otherwise it is exactly as advertised. I'm using this sensor submerged to control a water tank temperature.
Recommended Products