Your cart is empty.
Your cart is empty. BASIC Suntec Pump Repair Kit For Most Suntec & Beckett Model "A" Series Pumps.
Includes most common failed parts - Seal, Internal Diaphragm, Cover Gasket and Strainer.
Seal is 7/8" diameter x 1/4" high x 5/16 diameter shaft.
Diaphragm Fits on top of gear set. Be sure to spin shaft by hand while tightening the gear set.
Strainer measures 1 - 1 1/8" High.
Cover Gasket is full coverage, keeping contaminants out of the gear set.
The Lip Seal, Shaft Seal DOES NOT fit early bronze nosed, face seal pumps, such as 7016 & 7012.
nick Popelka
Reviewed in the United States on March 9, 2024
This was just what I needed
Wooks
Reviewed in the United States on January 12, 2024
The media could not be loaded.
Mikey T
Reviewed in the United States on September 21, 2023
Incomplete kit
Randy
Reviewed in the United States on May 1, 2023
This kit works great no more leaking heating oil.
M. Ellen C.
Reviewed in the United States on October 9, 2023
I have a Suntec A2VA-7116 pump. This says it works for it. All gaskets work great but the screen filter did not. The original filter fit snuggly over the pump body and the cover went on easily. The new filter appears to be the same physical size side by side, but it has a larger inner diameter allowing slop around the pump body. In addition, the center button on the blue cap was recessed on the original one and extended out on the new one causing the cover to be press fit onto the body. I tried to position, reposition twice, purged air and burner wouldn’t light. Cleaned old screen put it in and burner fired right up. So if I get this again, I will just use the gaskets.
jose
Reviewed in the United States on April 19, 2023
Missing my oil seal and inside gasket
Patricia Moore
Reviewed in the United States on March 5, 2022
All is well now Furnace is Repaired Thanks
George West
Reviewed in the United States on June 12, 2021
This kit was a perfect fit. My Furnace works Great now. DIY of course.
Recommended Products
