Shopping Cart

Your cart is empty.

Your cart is empty.

Battery Cap Removal and Installation Tool for SRO Red Dot

4.3 (2) Write Review
Free shipping on orders over $29.99

$17.50

$ 7 .99 $7.99

In Stock
  • Specialized Fitment: The location of the screw head, and especially the flat shape of it, on the SRO leaves much to be desired. This tool greatly reduces the chances of scratching the optic body, and most importantly the glass. Since this tool is MJF printed Nylon it is also much more forgiving than metal-on-metal or metal-on-glass contact. The SRO tool is tapered near the middle to allow it to be nearly perpendicular to the SRO, greatly easing the cap removal and installation.
  • Scratch Free: Multi Jet Fusion 3D-printed tool reduces the likelihood of scratching your optic compared to a coin, screwdriver, or other metal-on-metal contact. I have yet to scratch my battery cap, though your results could in theory vary.
  • BROS Compatible: The neck is purposely designed long enough to accommodate a BROS.
  • Usage Notes: Ensure you push the tool into the battery cap while you twist it. When re-tightening, go until it is snug and then stop. This is a plastic tool, and is not meant to be tightened like you would a tire lug nut.
  • Original, Innovative Design: 1700+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.


This Multi Jet Fusion printed tool is made of Nylon for high strength while not stratching your battery cap or optic lens. The neck of the tool is specifically made to work with a SRO with and without a BROS installed. Disclaimer: This product It is solely designed by Hammy3DPrints, with no associated with the manufacturer of the optic.


Bryan T
Reviewed in the United States on June 13, 2024
Works great.... The tool I wish I had found years ago! Love the free swag too!10 outta 10 would recommend!
Patrick
Reviewed in the United States on December 6, 2024
Does not have strength to twist off cap. Don’t buy.