Shopping Cart

Your cart is empty.

Your cart is empty.

BETAFPV ExpressLRS 915M OpenTX Mini Nano Receiver High Refresh Rate Long Range Performance for FPV Racing Drone

Free shipping on orders over $29.99

$18.99

$ 8 .99 $8.99

In Stock
  • 【ExpressLRS】 ExpressLRS is an open-source RC link for RC applications, based on Semtech Lora SX127x or SX1280 hardware for RX and TX respectively. This makes ExpressLRS one of the fastest RC links available while still offering long-range performance
  • 【ExpressLRS Receiver】BETAFPV Nano receiver is based on the ExpressLRS project, an open-source RC link for RC applications which aims to achieve the best possible link performance in both speeds, latency, and range suit for ELRS TX module or Nano bay, etc.
  • 【Crossfire Serial Protocol 】ExpressLRS uses the Crossfire serial protocol (AKA CRSF protocol) to communicate between the receiver and the flight controller board. So make sure your flight controller board supports the CRSF serial protocol. How to set up the CRSF protocol can be viewed on the fourth page of the manual.
  • 【Nano Receiver/Compact Design】This receiver only has 0.7 grams and the volume is 12mm*19mm which is very suitable for Tiny whoop because of the ultra light and Nano size.
  • [Configuration & Bind] Nano receiver could enter binding status by power on/off three times. Step: Plugin and unplug nano receiver three times; Make sure the LED is doing a quick double blink, which indicates the receiver is in bind mode; Make sure the RF TX module or radio transmitter enter binding status, which sends out a binding pulse; If the receiver has a solid light, it's bound.



Todd Jurgensen
Reviewed in the United States on February 28, 2024
Apparently theres an issue with the earlier batch of receivers, unfortunately I tried to use mine after the return window ended -_-
C W
Reviewed in the United States on February 20, 2023
I have not had a signal loss yet with this. Video cuts out first. The antenna is a quarter wave antenna and could be improved by a half-wave, but like I said... no signal loss in all my uses.
Judge
Reviewed in the United States on August 29, 2022
I love the fact that I can use all these different brands Tx and Rx together, just load the firmware and ready to fly.
Duffy Mazan
Reviewed in the United States on March 29, 2022
I bought the BetaFPV version of the ExpressLRS Nano nano receiver with some trepidation. I haven't had great experiences with BetaFPV products in the past and ExpressLRS has a reputation as being a bit finicky to configure.The receiver worked better than I expected. After powering up, it automatically went into Wifi Update mode after no activity for 60 seconds (as indicated by a fast-flashing status led). The update to the 2.3.0 firmware worked on the first try.Once the TX module and receiver were both updated, they instantly connected based on the custom binding phrase. Much better than the usual process of trying to hold down a tiny button while connecting power.Performance seems great with the stock antennas, although I haven't really tested the range.One star off for arriving with ancient version 1 firmware. Otherwise, a good purchase.
Ludwin Landaverde
Reviewed in the United States on April 4, 2022
It's a really good receiver, one thing though is that the antenna that came with it it's just too little for 915mhz but overall very good haven't had any issues with it.
Carr Fam
Reviewed in the United States on November 23, 2021
After realizing the antenna was only 5.6cm wide, I looked on the board and it states: "ELRS 2.4Ghz V1.0" Just to verify, I looked up the chip on the board (SX1280) and sure enough it's for 2.4ghz. How annoying.
Recommended Products