Your cart is empty.
Your cart is empty.Product Description
High Quality
Anti vibration pads are made of durable rubber and high density EVA foam. "rubber-EVA-rubber" sandwich structure which have stability,with wear and weather resistant,vibration isolator pads are water and oil resistant,unaffected by most chemicals
Non Slip Design
Rubber isolation pads feature stripe on top and bottom,increase friction for good slip resistance,hold equipment firmly in place and prevent it from moving
Kev
Reviewed in Canada on January 10, 2025
Used these under a large air compressor in the shop. They eliminate vibration noise with the floor, and make the compressor mush more quiet. It also doesn't travel on the floor - it stays put. Good investment.
Rivers
Reviewed in Canada on November 11, 2024
Just what I needed for our new gas furnace ,
Smitdiggly
Reviewed in the United States on October 10, 2024
Huge Difference! A little quieter but definitely killed the vibration and movement on a 60gal Air Compressor.
Neil R.
Reviewed in Canada on September 23, 2023
Installed a new 3/4hp Convertible Jet pump and it was a little noisy, so I bought these to put between the legs and the wooden crib that it sits on. Noticed a difference inside the cottage, 50% less vibration/noise.
g
Reviewed in the United States on July 7, 2023
Did not come as pictured, no pre drilled holes.
carl h.
Reviewed in the United States on July 3, 2023
I purchased a large stand up compressor with a higher air flow and larger tank And 150 plus pounds heavier than the old compressorI expected The new compressor to produce more running noise than the older compressor with 3 times the power and output air flowand I was correct in assuming thatthese pads reduced the Vibration transfer noise more than I expecting would occur but they were a huge improvement from the mounting pads I had purchased that was recommended by compressor company Which also required this compressor to be securely bolted to a concrete floorI am happy I purchased these to see if a improvement was possible And impressed how much difference between the two types of pads were
Ray
Reviewed in Canada on March 27, 2023
Work good but cheaper at Princess Auto.
rv8tor
Reviewed in the United States on December 21, 2023
These vibration pads (for my air compressor) are what I ordered and were delivered when promised. Just remember to let compressor sit on pads as in do not over torque the bolts holding down the compressor. One compressor manufacturer recommends a 1/16" gap between bolt and top washer so that compressor can vibrate freely on the pads. Too tight and the pads cannot do their job.
Tom Parsley
Reviewed in the United States on August 6, 2022
I had been chasing my air compressor across the garage. Hearing it rattle when it is running sounded lime a tank in the garage. Now all i hear is the compressor and it stabilized it so i could add air dryer on without worrying about something getting pulled off of the wall
paul borden
Reviewed in the United States on August 9, 2021
Bolted these directly to my 60 gal compressor that vibrated across the floor before I installed these. Quiet and compressor stays put. Had an odor out the package but I haven’t noticed again since install in a 20x20 garage.
david
Reviewed in the United States on October 9, 2021
My compressor creates 85-87db of noise. With pads under compressor, it creates 85-87db of noise.
Recommended Products