Your cart is empty.
Your cart is empty. BOJACK 0/2/4 Gauge AWG in-Line ANL Fuse Holder with 300 Amp Fuse No Wire Terminals Needed Inline Fuse Holder with Insulating Cover
Product information
ANL Fuse Holder:heat resistance, flame retardant, insulation, Easy installation without wire terminals
ANL Fuse:Good electrical conductivity, durability and heat resistance
Advantage
1.The fuse holder comes equipped with transparent covers allowing Heat-resistant and durable clear housing.
2.Strong conductivity it has overload fuse protection protection circuit.
Package include
1pcs Fuse holder、1pcs 300A ANL Fuse
Lonfu
Reviewed in the United States on March 6, 2025
a real 40 amp fuse holder. sturdy and easy to install.
Morgan W.
Reviewed in the United States on March 10, 2025
Works good. Fit with 1/0 cable nice. I did swap out the fuses for higher ones and ran 2 12s off it never had an issue. Pretty good quality for the price. And it looks nice with a clean setup. Cover was easy to install and remove for fuse access.
Mary
Reviewed in the United States on February 2, 2025
Easy to install, it was perfect.
Alfonso
Reviewed in the United States on January 16, 2025
I did a big three upgrade on my 98 Toyota RAV4 and I used the fuse for the wire that goes between the battery and alternator. It almost been a year and it’s holding up pretty good. Not only is it protecting the circuit but the case is handling the elements pretty good.
Gh
Reviewed in the United States on September 8, 2024
Screws that hold the fuse in were tapped on a angle so the screw only touches one side of the prong on the fuse and its loose thats no good! and it does not take 4 gauge wire as advertised when try tighten the set screw it falls in before the wire is tight thanks for wasting my time bo crap
BillC
Reviewed in the United States on March 30, 2024
The mounting lugs are good and substantial but are only held in place by the two case halves. There is only the main size on the lug with no reducer adapter. This is a good product but could have been made better if the lugs were captured in the molding of the lower case to facilitate fastening the conductors. Placing the Fuse last while holding both lugs in the lower case will avoid any damage from handling and the fit of the fuse could also be better, (on the straight fork of the fuse it only engages the Fastner =
anthony
Reviewed in the United States on December 27, 2024
Love the quality I needed a replacement for my old broken one. This work very well
Mike
Reviewed in the United States on December 24, 2024
Fit and works great
IRAK M.
Reviewed in Mexico on November 5, 2024
Cuesta un poco hacer la instalacion, seria bueno mejoraran un poco el diseño. Pero en general me gustaron
Recommended Products
