Your cart is empty.
Your cart is empty. BOJACK 300 pcs High Quality Variable Resistor 6mm Potentiometer Assortment Kit
Mechanical characteristics:
Rotation angle: 200 ° ± 20 °
Rotational torque: 60~150g.cm
Stop strength: 500g.cm
performance:
Plug-in method: Horizontal
Resistance range (Ohms): 100~2M Ohm
Resistance deviation: ±20%
Rated power: 0.1W
Maximum use voltage: 50V
Resistance change characteristics: B
Residual resistance: no more than 5% of the nominal resistance, the maximum does not exceed 30Ω
Rotation life: After 100 turns of no-load rotation, the resistance changes up to ±15%
Load life: load rated power for 3 hours, resistance change up to ± 5%
Product Description:
101--------100Ω----20 pcs
102--------1KΩ -----20 pcs
103--------10KΩ----20 pcs
104--------100KΩ--20 pcs
105--------1MΩ-----20 pcs
201--------200Ω----20 pcs
202--------2KΩ------20 pcs
203--------20KΩ----20 pcs
204--------200KΩ--20 pcs
205--------2MΩ-----20 pcs
304--------300KΩ----20 pcs
501--------500Ω------20 pcs
502--------5KΩ--------20 pcs
503--------50KΩ------20 pcs
504--------500KΩ----20 pcs
E. Cernek
Reviewed in the United States on July 9, 2024
I needed a variety of pot's for my breadboarding. These fit the requirement nicely. The quality seems good enough for my purposes and the price is right. However, I would need to do more digging if I had a production requirement; not familiar with the maker.
ggskip
Reviewed in the United States on March 5, 2024
This kit is well packed and well stocked. Good selection of resistor values and the ones that I have tried operated smoothly.
Sandra
Reviewed in the United States on December 12, 2024
I haven't found a bad one yet and don't expect to and the price was really good.
mrclassicman
Reviewed in the United States on April 3, 2024
Fit very well on pre drilled bread boards and works exactly as expected!
WeAreDivine
Reviewed in the United States on September 24, 2023
These are great, I use them all the time. You get a large quantity for a good price. I have had none of them feel so far. If you need a potentiometers, these are good value.
gerardo e.
Reviewed in Mexico on March 29, 2022
tiene una gran variedad de preset, pero sus valores no son nada exactos varían hasta un 30% de su valor y en algunos casos se necesitan valore con un máximo de variación del 10%.
ofenmann
Reviewed in the United States on June 26, 2021
They work but not for me. I was wanting to use them on a breadboard but the spacing is off a little for that. You can force them in but they may pop out at any time.
S. Steven Smith
Reviewed in the United States on May 1, 2021
This is a real nice kit with multiple pin mount potentiometer values. I very much appreciated that they put an identification label on both the top of the case and underside of the lid so you can see it when you open it. Nice touch! Components are numbered, not noted for resistance, so this is real important. Tested a few and values were pretty good, within tolerance levels you’d expect.
James R. Acker
Reviewed in the United States on November 19, 2021
Nice. The trimpots will last me a pretty long time. So far only used one, but it works perfectly. Used it first by testing, then on breadboard (fits perfectly) then soldered into perfboard. Nothing much else to say. Great value for the money.Update: they aren’t great actually for breadboards. But I was able to solder wires to them and at 250 deg. Soldering iron, did no harm to them and that is very good. I was going to complain slightly about the values, but I see actually so far all I measure are within the +- 20% range. In all cases so far they are often lower than rated. 500k ohm measure for example 430k or so. But that is within tolerance. Next time I will look for the same supplier but with solder lugs if they are available.
Recommended Products
