Shopping Cart

Your cart is empty.

Your cart is empty.

Boobrie 5-Pack SMA Female to U.FL IPX IPEX Right Angle Pigtail Coaxial Cable 12in RG178 Pigtail Antenna Wi-Fi Jumper Cable IPX IPEX-1 UFL to SMA Coax Cable for Wireless LAN Devices

4.9 (8) Write Review
Free shipping on orders over $29.99

$9.89

$ 4 .99 $4.99

In Stock

About this item

  • 🔗【Cable Type】: SMA Female (no pin) to IPX coaxial cable RG178; Cable length: 12inch(30cm); Impedance: 50 Ohm
  • ✔【Transmission Performance】：Superior transmission performance.Stable digital signals transmission and fast transmission speed.
  • ✔【Advantages】：Made of brass copper finished with Nickle Plated signal loss is very low. Easy to install, better signal transmission and corrosion protection.
  • ✔【Product Application】：Widely used in Antenna Applications, lora module, Mini PCI, Bluetooth module, Wi-Fi Radios, GPS module, WiFi USB and so on.
  • ✔【Package Included】 : 5pcs SMA Female to IPX cable rg178 12inch. ♥ We provide 12 months warranty and return service after the original purchase date. If there are any manufacturing defects in this product, please do not hesitate to contact our customer service team.


BOOBRIE SMA Female to U.FL IPX IPEX RF Coaxial RG178 Pigtail Jumper Cable 11.8in 5-Pack


BRX
Reviewed in the United States on February 24, 2025
I needed a way to extend an IPEX connector to SMA, which can be mounted to a project box, and allow me to use and test various antennae for the application. I experienced no signal loss or degradation and they all snap right into an IPEX connector.
Cary D.
Reviewed in the United States on February 10, 2025
Used in an engineering and development environment. Product seems to work fine. No issues.
Barkyhill
Reviewed in the United States on January 21, 2025
Well made cables with right-angle SMA jacks.Use to upgrade a WiFi router internal cable to an external jack for an antenna, Power Line repeater access point to external antenna (my use).Also good for your NanoVNA test/evaluation board.IPX connectors are not good for multiple connect/disconnect cycles. I was wondering how to extend the life of mine for training purposes.
Kevin Burtch
Reviewed in the United States on October 29, 2024
I used this to test some LoRa / Meshtastic antennas and they worked perfectly.
Customer
Reviewed in the United States on October 22, 2024
Works great, no issues
David K.
Reviewed in the United States on April 26, 2024
I like this IPEX to SMA adapter. It lets me perform SWR tests on the entire antenna and pigtail assembly. I can trust not only my antenna, but my wiring to the antenna.
Sal
Reviewed in the United States on April 28, 2022
They work very well! Just don't over tighten them with a wrench.
James
Reviewed in the United States on September 14, 2020
The U.FL connector is too loose for a reliable connection. The reference material I've found shows the center pin should be 0.5mm +/- 0.06mm and should extend to the height of the outer shield of the connector.But on these adapters, the center pin is not nearly 0.5mm but instead comes to a point. And it is also below the height of the outer shield of the connector.While this might work for some connectors, of the 10 I tried, none of them were secure and none of their connections were stable.