Your cart is empty.
Your cart is empty.Product Description
Jig Saw Blade, Material High Carbon Steel, Primary Saw Application Wood, Shank Type T, Teeth per Inch 10, Length 4 In., Application Laminated Particleboard, Chipboard, Plywood, Hard/Soft Wood and Plastics 3/16 to 1-1/4 In., Package Quantity 5
From the Manufacturer
This blade cuts wood, down cutting, plastic and laminates.
Douglas McCauley
Reviewed in the United States on February 16, 2025
It cut Wilsonart laminate for countertops pretty good. Some chipping. Needs tape on the surface
Wizard
Reviewed in the United States on June 22, 2024
Will be using in the future so I didn't comment on their specifics . They are not easy to find and prevent tear out of laminate. Appear to be high quality .
Edfinn
Reviewed in the United States on June 21, 2024
Got these to replace my years old and hours used Bosch blades, but didn't pay attention to the teeth cut, these cut down and cause my jigsaw to jump around too much. Very hard to use, I'm using a small saw so a bigger heavier one may be better, or this saw is not ideal for these blades.
Co Ut
Reviewed in the United States on March 14, 2024
Will buy again
JR
Reviewed in the United States on February 28, 2024
Just what you need when cutting vinyl plank flooring for odd install around odd shapes
kelly keenan
Reviewed in Canada on November 16, 2024
Because the teeth are pointed down, these blades will cause your saw to jump quite a bit. Get some blades where the teeth are pointed up away from the wood.Not recommended for the home DIYer.
Tom G
Reviewed in the United States on June 29, 2023
What can you say, Bosch still makes quality. Used these to cut a 1950's laminate countertop. Perfect, no chatter, or tear out. Impressed.
FeatherBay
Reviewed in the United States on April 23, 2021
Bosch is an excellent company. Good blades for cutting fine wood projects without splintering.
krut
Reviewed in Canada on January 21, 2019
Work ok
Art
Reviewed in the United States on April 29, 2009
I used these with a Bosch jig saw to cut laminate counters after they were installed. They were the post form type, and it made the whole job much easier cutting out sink holes from the top (no chips at all). Avoids flipping over a counter after cutting a large sink hole in the middle. Also it's easier to mark out on the top side. I used 3/4 plywood under the laminate counter, so the overall thickness where the holes were cut was 1 -1/2 inches.The blades may work in a standard jig saw but I did not try them. I ordered the countertops from hd, ready-made from the fabricator, straight runs of counter only, and recommend this approach -if you only do counter tops every 20 years or so..
Recommended Products
