Your cart is empty.
Your cart is empty.Product Description
The main body of the motorcycle cross bar is made of 6061-T6 aluminum alloy material with CNC machining and iii grade hard anodized surface.
The mounting holes of the motorcycle cross bar only compatible with handlebars with a diameter of 7/8'' (22mm).
Telescopic Design
Loosen the screws at both ends of the cross bar to adjust the length.
After adjusting the length, lock the screw.
Ken Waldron
Reviewed in the United States on March 6, 2025
This item is adjustable in length. However the adjustment is via a compression fitting rather than a screw. Yes there is a screw fitting at each end but that serves only to tighten the compression fitting. I purchased this to add some support to my handlebars, but the compression fitting can slide, even when tight. This should have been adjustable by a full length screw.
Matt3753
Reviewed in the United States on February 10, 2025
Great product works perfect. Solid!
Vida
Reviewed in the United States on September 8, 2024
Quality seems really nice. The install tool included was a bit fragile but I made sure to tighten it down pretty good also. Over all I like it a lot on my 2023 Honda Grom factory bars
MPD
Reviewed in the United States on June 2, 2024
Ordered other junk on Amazon, kept this one. Nicely designed, fit/finish better than most. Wish it was US made and not from China.
Jonathan Roy-Cardinal
Reviewed in Canada on June 17, 2024
Telle que décrite je vais voir sa fit
Matt
Reviewed in the United Kingdom on February 28, 2024
Does exactly what it says on the tin fits my 12 inch tall apehangers on my chopper easily good value for money
mitch
Reviewed in the United States on December 31, 2024
Works fine so far, no issues..
Ron saso
Reviewed in the United States on November 29, 2024
The product looks good and gives me a great place for my phone and drinking cup
Sean Anderson
Reviewed in the United States on October 21, 2024
Great for holding accessories.
Scottie
Reviewed in the United States on May 24, 2023
The previous support bar I ordered was a miserable failure. Only one end of the bar was adjustable, so after the installation, the bar was all the way to one side with a long threaded rod exposed. This bar has a really slick design. The middle section of the bar where I an going to mount my cameras actually slides right or left on the end bars. Get the ends where you want them on your bars and snug them up. If the middle bar easily slides side to side, the ends mounts are straight and tighten them up. Now slide the middle bar exactly where you want it and tighten up the end nuts. It was super easy and it looks great. The quality is very nice too. I definitely recommend this support bar if you want something nice.
Recommended Products