Your cart is empty.
Your cart is empty.Bronze Transmission Drive Gear For Metal Cutting Band Saw If you need one…here it is! Or get one for a spare. You never know when one is gonna go! This bronze transmission drive gear will fit nearly every Taiwan made metal cutting 4-1/2” X 6” band saw. 20 tooth gear 1.837” major diameter of gear .5945 wide. Overall width of approx. 1” 15mm (.5905”) shaft Approx 4” Long Shaft 5mm keyway about 1” long The 6202 BEARING shown in photos is optional. If you need the bearing, you can contact us. It is an additional $7.99 and must be asked for and paid for in your order. Otherwise you will receive the gear without the bearing.
Noah Berger
Reviewed in the United States on March 14, 2025
My older saw required a pin instead of a keyway. Drilled out the gear, put the pin in and it worked great. Purchased this used. Gear was destroyed from previous use, had grease in the gearbox. Use 140 weight gl4 rated oil.
Craigs
Reviewed in the United States on August 22, 2024
This gear took a couple weeks to get to me and then it was the size of a toy (small)- wasn't even close to fit ,I tried to drill it out and make work ,year later my saw still not working and it said on package my numbers for the model saw I have.
Steven Y.
Reviewed in the United States on January 13, 2024
I called and spoke with the gentleman that owns the store that was selling the parts. And he assured me that it would fit into my band saw, and it was the exact fit. Only thing I had to do was drill for a roll pin, and add oil and start cutting, it was a great replacement part and a great seller and I would buy again. Most people on the YouTube channel Don’t realize that you have to put the brass gear in first and then turn as you’re tapping the bearings shaft-worm gear down into it because of the way it all is designed.
Catherine Rose
Reviewed in the United States on July 17, 2022
This gear (and shaft) was timely received and installed perfectly in my old unit. And I was extremely delighted to also find included, with my package, a replacement worm gear (and shaft). My old worm gear was also worn, I could not find a replacement, so I had reluctantly committed to hand grinding and reinstalling to make it work. I am delighted!!
JeffK
Reviewed in the United States on June 5, 2022
I have a older 1983 saw and the brass gear wore out. The shafts did not fit my old saw and I had to drill a hole for the gear retaining roll pin that the old saw used. But all I needed was the gear and that with a little fitting( the pin hole) it works!
None Ya
Reviewed in the United States on May 9, 2021
The media could not be loaded.
Squints2c
Reviewed in the United States on November 1, 2017
Its not stated but this comes with the WORM GEAR as well. My old gear was 21 tooth and this replacement is 22. All I had to do was replace the worm gear as well. You do have to press off the bearing but they are not on real tight, it could most likely be done with a good vise and hammer. Both pieces fit great and the saw is more quiet that it ever was. Money well spent vs buying a replacement.
Jim L.
Reviewed in the United States on July 16, 2014
Bore size of gear shaft correct and tooth surface finish was very good. Tooth angle and radius cut was correct for my saw's worm gear. I had to reuse my saw's shaft, as it was totally different than the one that came with the gear. I had to drill a hole through the hub, as my worn-out gear was retained with a roll pin and drill and tap for a key-way set screw . All-in-all, this gear restored my saw from an anchor to a smooth running saw again with just a little fitting up to adapt it to my particular saw. Recommended.
Recommended Products
$11.67
$ 4 .99 $4.99