Your cart is empty.
Your cart is empty.SWITCH, ROCKER, SPDT, 16A, 250V, BLACK; Switch Operation:On-Off-On; Contact Configuration:SPDT; Illumination:Non Illuminated; Switch Mounting:Panel Mount; Actuator / Cap Colour:Black; Product Range:R Series; Contact Voltage VAC:125V RoHS Compliant: Yes
Ylo
Reviewed in the United States on February 28, 2025
This was a perfect replacement for the two-speed / center off switch on my leaf blower. At least on mine, no soldering required, and the switch just snaps into the hole that the old switch occupied. So far it works great, will see if it lasts as long as the first one (a couple of seasons).
bill purcell
Reviewed in the United States on January 23, 2025
correct electrical config dpst panel fitment of tention assist or panel load edge are wider then body of switch , can be over vor by easy of side pressure when installing from front ,
mazomv
Reviewed in the United States on January 10, 2025
Well made, and a perfect match for the switch in our Vermont Castings Direct Vent Gas Heater DV25. Easy to pop in. Saved a $250 service call.
Majestic
Reviewed in the United States on September 7, 2024
This is the exact fit for my pool pump motor which is two speeds high and low price was very good quality excellent and fits perfect on my motor.
RJ
Reviewed in the United States on May 16, 2024
This review is being written after a couple of years with this product. I have to tell you it is a solid switch. I’ve had it on my shop vac and I’ve left it out in the rain…still works. This product is a great buy to replace an old switch. Highly recommend.
Jay Hutchinson
Reviewed in the United States on December 17, 2024
Great replacement switch for gem car
dan
Reviewed in the United States on January 7, 2020
I really liked that the dimensions of the hole this switch fit into was listed in the specifications. It fit perfectly into our trailer's 12 volt light switch bracket. We used it to give us a night light in the bathroom with LED ceiling lights. Just put a resister between the two outer posts of the switch and the led lights on one of the outer posts. Then connect the power to the center post. You can change the resister to change the light output. You instantly have bright, off, dim lighting
Jamie T
Reviewed in the United States on March 7, 2017
Thanks Amazon. Just what I needed.
Recommended Products
