Your cart is empty.
Your cart is empty.Carriage Tray Wheels for Husqvarna Tilematic TS 250X, Tilematic TS 250XL, Target TileMatic G2, Felker Tilemaster Plus, & Tilemaster XL Plus Tile Saw. wheel size is 1 1/4 round
dave worrell
Reviewed in the United States on October 12, 2022
They fit fine. The black bolts go on front and then the adjustable height chrome bolts go on back and then you can set the adjustment.
Robert Washington
Reviewed in the United States on March 5, 2020
Perfect replacement. Works like new.
Customer
Reviewed in the United States on July 24, 2019
Not happy
Jose Gomez
Reviewed in the United States on July 11, 2019
Too expensive And staggering
Joaquin Candia
Reviewed in the United States on January 26, 2017
wheels were not exactly cheap, but well worth it
Customer
Reviewed in the United States on August 23, 2016
Had to shorten two of the studs by about a thread or two but other than that, they work fine.
Devil's Guard
Reviewed in the United States on April 25, 2016
Nothing like new wheels for the tray, trolley, cart, carriage etc. for your tile saw. My old ones were so worn it was difficult to make true cuts with out dramatically twisting the trays while pushing them. They are the same quality as the original wheels, good stuff. Kind of spendy, but sometimes one just has to bite the bullet. I needed 16 as I have two double trolley Felker tile saws., ouch!! Get some, your efforts to make true cuts will decrease along with your frustration level.
Jeffrey M. Doherty
Reviewed in the United States on October 2, 2013
I've gotten sets of wheels for my trays before and they were fine. I received this order and when I opened the bag there were two wheels like the picture with the thread going through the middle of the wheels and two with the thread offset to adjust the wheel. There is no need to adjust the wheel thee tray rides on two rails and the four wheels sit on them. normally you would install the four wheels in less then 10 minutes. with the adjustable wheels you have to install them , put the tray on the rails, lower one wheel, lift tray over and tighten wheel (hopefully it didn't move from position when turning tray over which happened to me the first time) ,put tray back down and do the same with the other wheel. That took a good 20 -30 minutes. I have double trays so it took longer. If you do order the whels call in order and make sure they are all the same as the picture.
Recommended Products
$25.00
$ 11 .99 $11.99