Your cart is empty.
Your cart is empty. This black screw mount power inlet has international current and voltage ratings of 10 amps at 250 VAC, has North American ratings of 15 amps at 125 VAC, and is suitable for a variety of electrical applications.
It has a polyamide housing for strength and thermal insulation, and nickel-plated brass terminals for conductivity and resistance to corrosion.
Its temperature range is -13 to +158(F).
Screw mounts enable secure mounting of the inlet to a panel, and three solder tabs allow for permanent attachment of conductors.
Use only with a 250V fuse
Tyran Wilson
Reviewed in the United States on March 1, 2025
The images of this CESS switch module are not of the product you will receive. The advert shows a 7 pin but what you get is a 3 pin device. Also the spec sheet is for a different maker, not the product you are getting so do not count on any of the dimensions given in the advert spec sheet image.
Israel Guajardo
Reviewed in the United States on November 6, 2024
Did the trick really well. I installed it on my arcade cabinet. Good quality. Nice touch having the neon light on the switch.
foo
Reviewed in the United States on November 18, 2024
10A is pushing it with the push connectors. Had a few burn out. Soldering instead seemed to have helped the situation.
Yuriy
Reviewed in the United States on November 15, 2024
The switches work well without any electrical or mechanical problems.Also, the fuse is very easy to replace and at the same time sits in the module strongly and reliably.The problems are of different kind.1. The contacts on the wiring side of the socket are not marked, so before use you need to check all connections with a multimeter. It was so easy just to stamp "L" and "N" on two of the contacts th same way as they stamped Ground sign at the ground line of the socket.2. The sockets would be way more convenient for use if they made internal wiring of the socket instead of making users to hand connect the switch with the cable wires.
Hephaestus01
Reviewed in the United States on April 30, 2023
Built a USB-controlled power receptacle, and this entry module provides the input power from the wall socket (to be switched on/off to a downstream load). While this unit is rated 125VAC/10A (1250W), I tested the whole box out with a 1500W space heater (~120VAC/12.5A) for 15 minutes. That was apparently a bit excessive, as the fuse section of this entry module got very, very warm, and afterwards the power switch became less reliable. While the unit *might* survive a max of 1250W, I would not run it past 1000W for very long.
Robert A. Finley
Reviewed in the United States on May 30, 2020
This is a nice A/C panel receptacle that comes with a fuse and lighted on/off switch. A great "all in one". Took off one star because it did not come with a wiring diagram. Make sure that the lighted switch is orientated correctly in the plastic housing. Power needs to come from the receptacle to the power prong not connected to the light. If the switch is upside down, the light will always be on regardless of switch position (on or off).
Customer
Reviewed in the United States on February 20, 2020
I did find that most of the wiring diagrams associated with this kind of product have the switch installed the other way around.
Alen
Reviewed in the United States on April 28, 2019
Would have been easier to instal with a wiring diagram, but very nice overall
Recommended Products
