Your cart is empty.
Your cart is empty.The Climax Metals M2C-30 is a high-quality clamping collar, perfect for both hard and soft shafts. Its unique design ensures full engagement with the shaft without causing any damage or marring. The collar provides 360-degree clamping force, ensuring a secure and reliable hold. The black oxide plating not only gives it a sleek look but also provides some resistance to corrosion. The screw length is approximate, with a length of 16mm and an M6 thread. The collar has a bore of 30mm, an outside diameter of 2-1/8 inches, and a width of 15mm. This product is made of mild steel and is available in the modern style and black color. The Climax Metals M2C-30 is a great choice for any clamping needs you may have.
Dana C Torres
Reviewed in the United States on January 6, 2025
It’s worked on the fanatic dd gt pro ,Chewpest fix available
Rodney deVillier
Reviewed in the United States on May 4, 2024
Solved my fanatec disconnect problem.
So awesome
Reviewed in the United States on December 15, 2024
Thank you for this product.!! I was having horrible disconnection issues with my dd pro, this was so easy to put in put it to 12 nm based on a YouTube video I saw and it has t had any more issues even on higher level of 8 nm the dd pro puts out!Also go to sour.gg and watch oppaville lol
ELOY
Reviewed in the United States on November 28, 2024
I wanted to use these for my fanatec but they don’t even fasten they just spin endlessly
Dave
Reviewed in the United States on April 4, 2024
Got for disconnect issue on Fanatec CSl DD 8nm. Fit perfectly. Just did 1 hour race zero issues! FINALLY! 30mm bore
TooledUp
Reviewed in the United States on April 26, 2024
I sought this part out for one reason only: To solve the wheel disconnect issue I was having with my CSL-DD wheel on my sim racing setup.The issue is, after some time, the wheel starts to back out of the stock single bolt clamping collar and eventually moves enough to cause the USB-C internal connection to unplug and disconnect the wheel. You can re-seat the wheel re-tighten the hex screw on the stock split collar, but a few days later, the issue repeats. Eventually, you will round out the fastener from repeated tightening and then you have a real problem that involves cutting metal.This part is THE solution. It is the correct inside diameter bore size (30mm). Don't buy an imperial measurement (like 1-1/4") collar that is a bit too small or a bit too large. You're just asking for future trouble. Buy the right size, which is 30mm. This collar is split in 2 places, which means 2 fasteners, which means a much more secure clamp. The outside diameter is MUCH larger than the stock collar and it is significantly heavier, but I have found these attributes to actually be beneficial and provide a greater sense of balance to the wheel shaft.I ran one revolution of black electrical tape on the driveshaft where the collar would go in order to provide some extra friction where the collar would clamp down. Installed the clamp, torquing the screws by hand and without a torque wrench. I think the torque spec the manufacturer suggests is 15nm, but just use your brain, make it tight but not gorilla arm tight and you will be fine.I have been using this for over a month and the wheel hasn't moved even a hundredth of an inch. I know because I checked it with a feeler gauge. Very happy with this purchase.
Instantaneous
Reviewed in the United States on April 12, 2024
Works wonders for the shaft. Kept it snug ever since installation
richard chong
Reviewed in Canada on June 22, 2023
great replacement collar for your sim racing Fanatec CSL DD
shawn
Reviewed in the United States on June 27, 2022
Perfect for my needs
Recommended Products
