Your cart is empty.
Your cart is empty.This is a SANDED caulk to match CBP/Polyblend sanded grout. Perfect for caulking along floor and wall joints where sanded grout was used. Moisture and UV resistant. Meets ASTM C834 Standards. Dries to touch in approx. 1 hour and should full cure in low moisture setting in 3-5 days. Color can vary by dye lots. All monitors show colors differently.
Don Jeffers
Reviewed in the United States on September 26, 2023
Fixed the problem
Mike Sparrow
Reviewed in the United States on July 7, 2023
Product was broken open and mashed. Caulk was spread out in envelope. Requesting a refund.
Terek
Reviewed in the United States on May 27, 2023
My tile guy said to use sanded caulk and it does work very well.
Motosmith
Reviewed in the United States on March 21, 2023
The color was great and the final finish was good. You must apply in very thin layers to fill a crack because the product cracks as it dries.
LISA
Reviewed in the United States on April 18, 2022
TERRIBLE CRACKING HORRIBLE CLEAN UP HAD TO GO OVER THREE TIMES TO GET RID OF CRACKS.
Critic
Reviewed in the United States on February 8, 2021
Perfect color match. The only issue is that it dries almost immediately. Not possible to work it except within seconds of installation.
A. Armstrong
Reviewed in the United States on August 31, 2020
Color matched perfectly and product delivered promptly. Only wish could get these color caulk products in smaller, squeeze tubes. By time need to re-caulk again, most likely the big tube will be useless... So cost is substantial versus what is needed...
Recommended Products
$129.99
$ 60 .99 $60.99