Your cart is empty.
Your cart is empty.Step 1:
- Prepare the floor with the Concrete DNA Diamond Pad with Resins (ASIN: B06XXC1VVV). This is the 30 grit prep pad.
- Run the pad with plenty of water under a low speed floor buffer with our Super Blue product diluted at a minimum of 9 parts water. (ASIN: B01H7KGEUA)
- Squeegee the water and remove from the floor with a wet/dry squeegee vac
- Ensure the floor is clean from dust and footprints. Let the floor dry completely
- Spray the floor with the stain and ensure 100% coverage.
- Let the stain dry on the floor. When it is dry the stain is done reacting.
- Thoroughly flush the residue from the stain off the floor with water and clean the floor free from dust. Tip: If you run your finger over the floor and your finger picks up residue continue flushing until residue is gone
- Let the floor dry completely overnight
- Apply Ez Seal (ASIN: B01H7L8G3M) with a 3/8” nap roller
- Apply at least 2 thin coats
- Allow Ez Seal to dry for at least 12 hours before applying Ez-Glo (ASIN: B01H7MJ8JM)
- Apply at least 1 coat of Ez-Glo by using a microfiber mop
Renee
Reviewed in the United States on July 22, 2023
I read and reread all instructions. Power washed patio 8x10 for over 1 1/2 hours, wasn’t real souled, wanted to do a great job. Then let dry, I then applied the etcher per manufacture directions and worked it in with a scrubber, rinsed and allied to dry. Applied acid stain and I noticed right away as drying that the stain disappeared before my eyes, I did a reapply and same thing. It only took in a few small areas.I’m not going to say it’s a bad product, it didn’t work for me and still scratching my head. I’m not use to failing at a project so I took it hard.
Matt
Reviewed in the United States on May 25, 2017
Just looked like a weak tea color, could be my fault as first time using it. But, was not really happy with this particular color.
Recommended Products
