Your cart is empty.
Your cart is empty.Peter Lau
Reviewed in the United States on May 18, 2024
I coated the plywood with primer and topped it with Countryman Coatings - 100% Silicone Roof Coating. It holds up very well in the middle of the desert. Highly recommended.
bookknight
Reviewed in the United States on February 11, 2024
I have a flat roof on my family room, it's either TPO or vinyl. Not sure which. A tiny split deleloped in a seam near a plumbing vent, allowing a slow trickle of water to get in the house. I researched options and settled on 100% silicone. The big box retailers sell it by the gallon so i was happy to find a quart size on Amazon. I cleaned the repair area with warm water and TSP, rinsed it, and allowed it to dry overnight. When you apply the silicone be prepared, it is thick. I poured the can into a roller tray , used a 3/4" nap mini roller, then smoothed it a little with a brush. Wear gloves, the stuff is sticky.
amanda conner
Reviewed in the United States on October 20, 2024
Easy to apply. Dried quickly and worked fantastic for what I got it for
Kelly F
Reviewed in the United States on January 14, 2024
I bought a quart to coat the seams and around the vents on my motor home. In the past, I used self leveling sealant from a caulking gun tube. This product works so much better. And the finished product looked great. Use an inexpensive brush so you don't, have to clean up. I had a couple drips and I was able to scrape them off with a plastic putty knife. Make sure you scrub the surfaces with a stiff bristle brush and soap. Rinse and wait for the surface to dry before applying the coating. I used a leaf blower to speed up the drying process.
HomeTheaterGuru
Reviewed in the United States on April 21, 2024
Silicone is expensive. If you only have to patch up some small areas, why buy a large container that may dry out before you get to use it all? This size container is perfect for what I needed.after my new hvac was installed.
Lyle Messinger
Reviewed in the United States on December 5, 2023
Actually for as little as I got, it covers a lot of area and seems to hold up well. a bit expensive but you know what they say ... you get what you pay for. It's worth the $$$
Nichesound
Reviewed in the United States on December 16, 2023
Depending on the size and area, with one or two quarts of this you stuff, you can drip this on your roof and use a roller to saturate into shingles. Let this material set in a few hours and repeat twice or three times...the problems with roofs is that the nails under the shingles will sometimes let water migrate into the wood and finally into the area below. This can of silicon is made to fix this problem. And because it is NOT wat soluble it won’t be a problem when it RAINS!!!
Jill
Reviewed in the United States on December 13, 2022
I purchased a used fiberglass truck topper that I soon discovered had lost much of its gelcoat. Moisture was seeping in from the top, as well as outright leaking through during heavier rain. I honestly wasn't sure this product would be the answer, but it was priced right and was available in smaller quantities compared to other coating products. It worked fantastic! I coated the top of my truck cap with it and I am very pleased so far with how it worked. I have not noticed any seepage or leaking at all from the areas coated with this product. I actually wish I would have just done the whole thing, but I wasn't sure I would have enough nor how it would work being applied to vertical surfaces. I am considering ordering more to re-coat the top of my 20+ year old RV.
Recommended Products