Your cart is empty.
Your cart is empty.Length (Inches) (Inch): 11-Inch Finish On Handle(S): Red Vinyl Grip. Forms Tabs To Secure Vinyl Siding
Kacey Green
Reviewed in the United States on May 2, 2024
I don't know if I did it right or if it had the desired effect, but the siding is still where I put it.
Rebecca
Reviewed in the United States on September 25, 2023
I do home repairs. A couple times in the last year I needed to finish the last top row of siding and these allow me to make a slot/bump that locks in the last piece.
Jason
Reviewed in Canada on September 10, 2023
Worked good, I used it for clipping into undersil trim.I used undersil trim at the top of my siding and also under large windows.
Dan
Reviewed in Canada on August 7, 2023
I’m redoing the siding on my house. This tool is simple but great. You will need this if you’re doing vinyl siding. It locks the top piece of siding in place nicely.
Jack Roberts
Reviewed in Canada on February 3, 2023
Gets the job done and great value for the money
J. Brown
Reviewed in the United States on August 16, 2022
Not a pro tool. You can tell by the feel and action. But it does do the job. You have to be careful though, if you punch through hard and quick, or your siding is brittle at all, this will punch am oblong hole instead of a tab that is connected on one side. The tab is supposed to be there to lock piece above.
Chad D. Mamerow
Reviewed in the United States on July 29, 2022
Simple tool, but it worked great. Completed siding on my entire house and this helped. Longer handle makes it user to use, so on the long pieces, your hand doesn't get tired.
Bob
Reviewed in the United States on October 17, 2022
Worked like a champ and very easy!
Hotrod
Reviewed in Canada on July 1, 2020
This tool comes in handy when you are running the siding horizontally and reach the top of a wall. It puts a small tab bending out at 90 degrees in the cut edge of the siding. This you repeat every 8". Its sufficient to stop the siding pulling out of the finishing trim it goes into.
Oxford Metal
Reviewed in Canada on February 16, 2019
Great for making nail slots. A bit tricky to get nice jtrim cleats without breaking through the siding.
Ziji
Reviewed in the United States on January 25, 2019
Works well for making tabs along top edge of fascia in order to attach it into the undersill trim. It WILL punch all the way through the fascia in thinner spots, leaving a hole, rather than a tab, as stated in other reviews.. I found that it works just as well to use it to make a bump in the fascia, rather than punching all the way through to make a tab. The undersill trim will hold the fascia very firmly with only bumps. I know this because I had to take the fascia back down after installing it.. Was very difficult to remove from undersill trim..
Steve H.
Reviewed in the United States on June 11, 2015
If you have to put vinyl up under an eve or somewhere where you can't use a full piece, you need to create some kind of tab in it for it to stay up correctly. I had tried using just the bottom lip before but if you have any kind of wind they usually end up falling out. That gets old real quick, especially in areas where you need to get out an extension latter to put them up.This tool makes takes really quick and is super easy to use. No more vinyl on the ground for me.
G. Stewart II
Reviewed in the United States on November 18, 2014
Worked great! I mean...it is what it is really...but with the mass amount of cut downs I needed to do on this house when I sided it was definitely worth the medial price I paid...much cheaper than at the Chain Stores nearby for the exact same item.
Recommended Products
