Your cart is empty.
Your cart is empty.CTS Long Thread 500K Push Pull Audio Pot
Rosy
Reviewed in Mexico on July 22, 2024
Buen producto
Treyday6986
Reviewed in the United States on March 21, 2024
Top notch, premium pot. Smooth, flawless sweep and quality made. All of my guitars have humbuckers and I use only these pots or the non pp, same values. Also the tolerance is even closer than described which is always welcome!
huber c.
Reviewed in the United States on October 8, 2024
Se instalaron en mi guitarra ltd, se comporta genial, la respuesta al movimiento es muy precisa, se instaló en volumen y dos cts en tono
Dev02
Reviewed in the United States on November 8, 2023
Put this in an 80’s Gibson after getting a 4-wire bridge. Loved it so much I ordered a 4-wire neck PU from Gibson and another of these to go with it.The pot feels great and works like a champ. Nothing sloppy about it.If you’re using this for splitting I recommend the PRS resistor trick (I used a variable resistor so I could dial it in). Otherwise, at least with the Gibson 490 and 498 they get a little too thin.
Joel Harding
Reviewed in the United States on December 9, 2022
These are supposed to be great pots but I'll never use these again. Total pain to solder to the little holes on the side. I'm using Alpha or something else with side lugs.
william demster
Reviewed in the United States on June 11, 2021
Soldering in place is very very tricky. Definitely do your solder work outside the instrument and be careful where you solder grounds as certain parts do not take solder well at all
N. McArthur
Reviewed in the United States on November 28, 2021
This has thin enough control body to fit the thinner cavity of the Les Paul Classic.
Ed Strine
Reviewed in the United States on February 24, 2020
I used this to replace a pot on a gibson circuit board. Had to change the board from the switch to the original from gibson to make it work but it works fine now.
カスタマー
Reviewed in Japan on April 17, 2020
国産のものも持っていますが、音がこもってしまいがちでした。こちらは音のこもりが少なく、操作もかっちりしていておすすめです。国産のものよりやや本体が大きめなので、つける場所は予め確認が必要です。3カ月使用し、ノブ変えようとしてイモネジ緩めて引っ張ったら、シャフトが抜けました(￣∀￣;)バラして見たところ、シャフトの端がスイッチ部分のエンジニアプラスチック製のブロックについているのですが、シャフトがブロックから外れないようにしていると思しき部品がかなり柔らかいプラスチック製で、それが曲がって外れた事がわかりました。小さなバネもあって、元々どのように組み合わせてあったのか分からないため、廃棄する事に。引っ張り方向への強度はかなり弱いようです('・ω・｀)
Carlos La Rosa
Reviewed in the United States on April 6, 2019
Excelente producto
Recommended Products
