Your cart is empty.
Your cart is empty.Danco O'Ring 5/16 Inch x 1/2 Inch x 3/32 Inch No 35711W
Gadgetlover
Reviewed in the United States on August 20, 2024
Just simple O Rings. Nothing extravagant about them. I’ve used 5 so far without any drama.
Scott McClain
Reviewed in the United States on May 31, 2024
I used to protect the firing pin retention pin on my CZ's while I dry fire. Perfect fit for that.
Davis711
Reviewed in the United States on April 21, 2024
Bought to use in my hammer fired pistols to reduce impact on firing pin when dry firing.
C. Fontana
Reviewed in the United States on September 30, 2023
We used this for a replacement release valve for our pentagram pool filter. Much cheaper than the one one.m
Joseloy
Reviewed in the United States on August 27, 2023
Arrived in time, stated quantity, good material.
DBC
Reviewed in the United States on April 1, 2023
I use these in my CZ hammer-fired pistols for dry fire practice. They fit perfectly between the hammer and firing pin.
Dang U 812
Reviewed in the United States on October 16, 2022
Good value. Worked great for replacing o rings on a few beer kegs.
M
Reviewed in the United States on April 2, 2019
This is handy to throw in the slot in the slide where the hammer hits the firing pin. Should fit most DA/SA type pistol. For larger ones, you might need a different size, but it fits the CZ and Sig pistols I've tried.Don't forget to remove it when done dry-firing, especially if it's your carry pistol, or you'll be hearing a dull thud vs. a bang when you most need it to do the latter.
Recommended Products
