Your cart is empty.
Your cart is empty. Upgraded block up design Closely fit motors and good covering on the motor top.
Dustproof,Waterproof,Scratchproof Protection Case Cover Mounts.
Quick and easy installation and removal, keeping the seamless elegant design of the Mini 4 Pro/ Mini 3 Pro / Mini 3 .
Aluminum . Light weight and durable,hardly affects flying endurance. Darkhorse Aluminum Motor Cover Cap for Mavic Mini
Tip: Please check all parts of the drone to confirm they are normal. Make sure the motor cover is installed correctly and the screws tightened before flying.
Note: Incorrect installation and use may cause the drone to crash! !
Rayster
Reviewed in the United States on February 19, 2025
I avoid rain but these should help keep rain out of the motors.
Tony
Reviewed in the United States on September 16, 2024
They are fine just cause the drone moters to run hoter in winter they will be fine
Nathan Warner
Reviewed in the United States on May 20, 2024
Fits nice. Looks cool. Does the job.
P64imp
Reviewed in the United States on May 11, 2024
The mini 4 pro has 2 types of propellers. One set matches the front left and back right, the other set matches the front right and back left. Installation goes in an X pattern for match - When installing i found the Front Right and Back Left installed properly, but the Front Left and Back Right are way too tight. The difference in the propeller base snugs up against the cover so much that it takes moderate hand force to move the blades. They do NOT free float like the other pair as they should. They are designed to free float and not tighten to hand force.This can damage your drone if you run it like this. Don't pick these up for the 4 - looks like they lazily kept the same design from the 3 and decided to pitch it for the 4 as though it's true to spec. It is NOT, and can damage your expensive drone!
Black Adder Design & Engineering
Reviewed in the United States on July 21, 2023
These will not work with Master Airscrew Stealth blades. They fit with stock DJI blades just fine.
Blaine Ehrman
Reviewed in the United States on June 8, 2023
I wasn’t able to tighten the screws, if I did the blades would no longer swing free. I had to back them off and hope locktight would keep the screws in place but they are so tiny I just can’t do that. It dawned on me that I’m not using factory props, mine are Master Airscrew and maybe that’s the problem. I’m not giving them up for dust covers. As far as I’m concerned they are a solution looking for a problem. Spend your money on a nice landing pad. I believe every drone with brushless motors is pretty much open at the top. There are thousands of them around the world and they are not falling out of the sky and if that should happen it likely wasn’t something dust covers would have prevented!
Jacob S.
Reviewed in the United States on May 22, 2023
They do have a little slack but when you’re flying it has no effect on anything and it makes the drone look a lot better and not as plain. Would buy again and can now fly in light rain without any worries!
noakes
Reviewed in the United States on November 30, 2023
Great product to use to cover your motors for just a little more peace of mind. Installation was easy (minus dropping a screw from the drone propeller). And adds a small hint of flare to your drone to make it more yours. Good price and a nice touch for the mini 4 pro.
Recommended Products
$106.99
$ 48 .99 $48.99