Your cart is empty.
Your cart is empty.Product Description
Reversing relay module. Powers any reversing motor equipment, can be used for any application that requires the ability to reverse motion.
VIN connected to the positive of power supply , GND connected to the negative of power supply;
P+ connected to the positive of motor power supply, P- connected to the negative of motor power supply;
M + & M- connected to both ends of the motor
After power, D1 flashes for 3 times, D2 off, M+ output positive, M- output negative, motor forward; After a time delay T1, D2 on, M+ output negative, M- output positive, motor reversal; After a time delay T2, D2 off, M+ output positive, M- output negative, motor forward; And so on.
T1: motor forward delay time, default 0.1-5000 seconds adjustable (step 0.1 seconds)
T2: motor reverse delay time, default 0.1-5000 seconds adjustable (step 0.1 seconds)
By "Time multiple selection" setting, the maximum delay is up to 40,000 seconds
GOOD PERFORMANCE -- The motor timer relay module with good performance, also is easy to install and has a long service life.
WIDE APPLICATION -- The control board can control solenoid valve, pumps, motors, lights and other running freely.
DSP
Reviewed in the United States on September 25, 2024
It got the job done, so I can't complain too much, but it is impossible to get the timing precise.
John Hupp
Reviewed in the United States on June 30, 2024
Item stopped working. I have ordered two replacement modules that won't even power up.
NostalgiaXp
Reviewed in the United States on May 1, 2024
The circuit does not work as it should. I hope to have better luck with the replacement I request.
Roshan
Reviewed in the United States on March 29, 2024
it work for a while when I got it then reverse light just blinking unable set then programming button stop working then will work for a 1 minute then remain stick on forward then switch off no light and haven't work since when finish the housing for it haven't got chance to use it
Jesus and me Creations
Reviewed in the United States on February 4, 2024
I'm sorry but I'm not one and therefore I can't figure out the instructions that this gentleman gives for this module. I have tried over and over and I really want to use it and I have even read the "simplified" version of the instructions but to no avail. I did not return the module because I am not a genius and therefore it is my fault somehow even though I am highly intelligent. :-) If you aren't a genius, don't buy this.
Gerret Mcwhorter
Reviewed in the United States on December 6, 2024
Find an easy YouTube video to teach you how to program. I was using in less than 10 minutes.
pookie
Reviewed in the United States on January 26, 2024
Ok set up is easy it comes with no directions but the directions are on the page you are buying from. I wanted to use this on my model rr for make a action scene with a hot air balloon riding and landing. I wanted it to pause in air then lower down. This unit will only go back and forward. There is no pause delay. You can set the motor time forward and backwards but no pause betythe two. So standby mode is just for set up.
Ohnonothimagen
Reviewed in the United States on March 9, 2023
Works great for my use case; however "programming" the cycle time by means of a single switch and the timing of a flashing LED is primitive at best....but with patience it can be made to work. Other reviewers have stated having problems and I found on the unit I received, the voltage to the control logic had to be at least 5.4 VDC before it was reliable. Straight 5 volts was insufficient.
Recommended Products