Your cart is empty.
Your cart is empty.Designed to use with Deckorators Classic Balusters, these connectors are used to connect round balusters to the rail. These connectors install seamlessly on the top and bottom of deck rails to achieve a flawless connection, eliminating visible holes, and can be used with wood, composite, and aluminum railings. Each 200 pack comes with stainless steel screws and will install 100 Deckorators Classic Balusters.
Customer
Reviewed in the United States on June 6, 2023
Good, simple system. Does NOT come with the required square screw tip. Not a common screw so make sure you have a couple square bits before time of install. Would have been 5 star if not for that issue.
Matt
Reviewed in the United States on June 10, 2023
Does good at holding rods in place. Would like to see them, include a a template to make it easier to use.
liloldfunkydude
Reviewed in the United States on March 22, 2023
Excellent product. Well made and would buy again.. Would be nice if a tool to screw the screws in would be helpful.
charles f. megginson
Reviewed in the United States on October 7, 2023
I read reviews before my purchase, and had no issues with the square drive screws. I personally don't care for square drive, but they got the job done well. The diameter of the base is exactly the same as the balusters and visually great.
Matt Sherwood
Reviewed in the United States on August 29, 2022
I purchased these to install some 26 X 3/4 inch round black balusters on a railing surrounding my basement stairwell. These worked great. They are a plastic/nylon material and come with stainless steel #2 square drive wood screws for install. I laid out the 2 X 4 and predrilled the screw holes with a very small drill bit so the screws would have enough material for a good bite. I installed the screws by hand with a hand screwdriver for a snug but not too tight fit. These worked great and look fantastic. They blend in with the balusters perfectly. You don't even know they are there. A tip for install is to install the bottom 2 X 4, slip the balusters over the bottom row and tilt the top 2 X 4 into the balusters. Starting from one end and trying to align each baluster is too time consuming and aggravating. I also assembled the longer runs with a 1/4 inch threaded rod, recessed nuts and washers thru a center baluster and thru these and the 2 X 4 . Another reviewer used 3/8" rod but that's kind of an overkill. It also helps with keeping everything tight if the 2 X 4s warp.
Linda Chavez
Reviewed in the United States on February 27, 2022
Great idea but didn't work for 3/4" pipe only 1/2" so couldn't use them
Ptah
Reviewed in the United States on January 5, 2022
Looks great until the rails warp. Drill holes for the 3/4" balusters (unless you are absolutely sure your rails will not warp).
Customer
Reviewed in the United States on December 14, 2020
Easy to install and use
Recommended Products
